Makita TD111DZ - User Manual

Page 2 - SPECIFICATIONS; Symbols; Intended use; SAFETY WARNINGS; General power tool safety warnings; Save all warnings and instruc-

2 ENGLISH SPECIFICATIONS Model: TD111D Fastening capacities Machine screw 4 mm - 8 mm Standard bolt 5 mm - 14 mm High tensile bolt 5 mm - 12 mm No load speed Hard impact mode 0 - 3,000 min -1 Soft impact mode 0 - 1,300 min -1 Impacts per minute Hard impact mode 0 - 3,900 min -1 Soft impact mode 0 - ...

Page 3 - Cordless impact driver safety; SAVE THESE INSTRUCTIONS.

3 ENGLISH Personal Safety 1. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or med - ication. A moment of inattention while operating power tools may result in serious persona...

Page 4 - Important safety instructions for; FUNCTIONAL; Installing or removing battery; Battery protection system

4 ENGLISH Important safety instructions for battery cartridge 1. Before using battery cartridge, read all instruc- tions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively sh...

Page 5 - Indicating the remaining battery; Switch action; Lighting up the front lamp

5 ENGLISH Overloaded: The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. If the tool does not start, the battery is overheated. ...

Page 6 - Reversing switch action

6 ENGLISH 1 ► 1. Button Pull the switch trigger to turn on the lamp. To turn off, release it. The lamp goes out approximately 10 seconds after releasing the switch trigger. To keep the lamp off, turn off the lamp status. To turn off the lamp status, first pull and release the switch trigger. And the...

Page 7 - ASSEMBLY; Installing or removing driver bit/

7 ENGLISH Impact force grade displayed on panel Maximum blows Purpose Example of application Hard 3,900 min -1 (/min) Tightening when force and speed are desired. Tightening wood screws, tightening bolts. Soft 1,600 min -1 (/min) Tightening with less force to avoid screw thread breakage. Tightening ...

Page 8 - Installing hook; OPERATION

8 ENGLISH 1 3 2 ► 1. Driver bit 2. Bit-piece 3. Sleeve To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will...

Page 9 - Using holster

9 ENGLISH High tensile bolt 3 2 1 N• m (kgf•cm ) 2.0 1.0 0 80 (816) 60 (612) 40 (408) 20 (204) 3.0 100 (1,020) 120 (1,224) M10 M12 M12 M8 M8 M10 1. Fastening time (second) 2. Fastening torque 3. Proper fastening torque corresponding to each bolt diameter Hold the tool firmly and place the point of t...

Page 12 - Makita Corporation

Makita Corporation www.makita.com 885522-9 EN 20160511