Liebherr HC1011 - Manual - manualsarea.com

Page 2 - General safety information

Contents 1 General safety information........................... 2 2 Setting up the appliance............................... 2 3 Changing the door hinges............................ 3 3.1 To detach the soft stop mechanism.................. 3 3.2 Reversing the door.......................................

Page 3 - Changing the door hinges

u Examine the unit and packaging for shipping damage. Contact the carrier immediately if you suspect there is any damage. u Note the type (model, number), index, appliance/serial number, date of purchase and where purchased on the spaces provided in see Appliance Information. u Remove anything attac...

Page 4 - Kitchen Cabinet Airflow; Kitchen Cabinet Construction

u Screw in ball stud Fig. 3 (3) together with the soft stop mechanism Fig. 3 (2) in the fastening hole. u Re-attach all covers Fig. 2 (5,6,7,8) . 4 Kitchen Cabinet Construction This is a fully integrated appliance which means that it is fully enclosed by a kitchen cabinet. This type of cabinet must ...

Page 5 - Designing the Kitchen Cabinet

Fig. 6 u In the cabinet base, cut out a ventilation opening that is 17-23/32 in. (450 mm) in width and 2-7/32 in. (56 mm) in height. u Insert ventilation grille Fig. 6 (3) into the cabinet base cut- out Fig. 6 (1) . u From the back side, slide the snap-fits Fig. 6 (2) into the grille until the hooks...

Page 8 - Installation; Water supply

u The total opening of the cabinet (i.e. 70-3/8 in. (1788 mm)) plus the thickness of the top as well as the floor board (usually 3/4 in. (19 mm)) minus the height of the freezer door panel (xxx in. (xxx mm)) as calculated above and subtract the width of the gap (approximately 1/8 in. (3 mm)): 70-3/8...

Page 9 - Assembling the appliance; Installation

Note u Before assembling the unit door, make sure that the per- mitted weight for the unit doors is not exceeded. u Otherwise damage to the hinges and malfunctions aris- ing from this cannot be ruled out. Maximum weight of unit door Fridge compart- ment door 30.5 lbs (14 kg) Freezer compart- ment do...

Page 11 - Fitting the unit doors

u Slightly loosen the screws Fig. 20 (51) . u Secure the bottom mount- ing bracket Fig. 20 (50) to the unit wall with a ø4x19 chipboard screw Fig. 20 (29) . u Break off the protruding end of the cover Fig. 20 (53) . u Tighten the screws Fig. 20 (51) . u Place the cover Fig. 20 (54) into position on ...

Page 12 - Connecting the appliance

u To align the unit door in depth Z: Undo the screws Fig. 25 (36) at the top and the hex head screws Fig. 25 (35) at the bottom using the ring wrench Fig. 25 (37) supplied, then move the door. u Do not allow the knobs and sealing lips to come into contact with the door - im- portant for function! u ...

Liebherr HC1011 - Manual

Table of Contents:

Summary

Other Liebherr Models