Liebherr 7082 133-00 - Manual

Page 3 - Installation dimensions; The water shut-off valve must not sit directly above the

GB 13 Installation dimensions The ice maker is fitted in the freezer compartment of the combined refrigerator-freezer. It must be connected to the mains water sup- ply to work. The water shut-off valve must be positioned within the areas marked in grey. The socket must be positioned within the areas...

Page 4 - Mounting the anti-tipping device; Wall; Connection to the water supply

14 Mounting the anti-tipping device WARNING! The supplied anti-tipping bracket must be installed in all cases. This prevents the appliance from tipping over when the fully loaded door is opened. Installation:1. Mark the centre line of the appliance on the floor. Align the anti-tipping bracket centre...

Page 6 - Levelling the appliance; The front feet of the appliance must be firmly placed on the; Fastening the appliance in the recess

16 Levelling the appliance 1. Adjust the height of the appliance at the front by twisting the adjustable feet 1 (A/F 27). Caution! The front feet of the appliance must be firmly placed on the floor. 2. Adjust the height of the appliance at the rear by turning the adjusting bars 2 (A/F 5). Turn the a...

Page 7 - Before fitting the door panels; The securing nuts are needed for re-mounting the pre-; Panel dimensions; Maximum panel weight

GB 17 Before fitting the door panels Remove the cover 1 and unscrew the top and bottom attach- ment brackets 2 from the refrigerator door. These attachment brackets will be mounted onto the refrigerator door panel. Important! The securing nuts are needed for re-mounting the pre- assembled door panel...

Page 8 - Mounting the attachment brackets onto the door panels

18 Mounting the attachment brackets onto the door panels 1. Draw a line 1041 mm from the bottom side of the door panel.2. Draw a further line 107.5 mm from the bottom side of the door panel.3. Align one of the refrigerator door attachment brackets to the top line, as shown in the illustration below,...

Page 9 - Mounting the refrigerator panel

GB 19 Mounting the refrigerator panel fig. A fig. B fig. C fig. D 1. Screw in the adjusting pins on the underside of the refrigerator door completely (fig. A). 2. Open the refrigerator door and suspend the refrigerator panel on the top adjusting pins (fig. B). 3. Screw securing nuts onto the adjusti...

Page 10 - adjust the door panel as displayed in fig. G and then retighten

20 fig. E fig. F 8. Remove the adjusting pins (bottom of the refrigerator door) until these touch the attachment bracket (fig. E). 9. Screw on the securing nuts and tighten (fig. F). 11. Click the top and bottom covers into place (fig. H). fig. H fig. G 10. Undo the three screws on the top of the at...

Liebherr 7082 133-00 - Manual

Table of Contents:

Summary

Other Liebherr Models