Liebherr 20707 - Manual - manualsarea.com

Page 2 - General safety information

Contents 1 General safety information........................... 2 2 Setting up the appliance............................... 2 3 Changing the door hinges............................ 3 3.1 To detach the soft stop mechanism.................. 3 3.2 Reversing the door.......................................

Page 3 - To detach the soft stop; Changing the door hinges

u Examine the unit and packaging for shipping damage. Contact the carrier immediately if you suspect there is any damage. u Note the type (model, number), index, appliance/serial number, date of purchase and where purchased on the spaces provided in see Appliance Information. u Remove anything attac...

Page 4 - Kitchen Cabinet Airflow; Kitchen Cabinet Construction

u Screw in ball stud Fig. 3 (3) together with the soft stop mechanism Fig. 3 (2) in the fastening hole. u Re-attach all covers Fig. 2 (5,6,7,8) . 4 Kitchen Cabinet Construction This is a fully integrated appliance which means that it is fully enclosed by a kitchen cabinet. This type of cabinet must ...

Page 5 - Designing the Kitchen Cabinet

Fig. 6 u In the cabinet base, cut out a ventilation opening that is 17-23/32 in. (450 mm) in width and 2-7/32 in. (56 mm) in height. u Insert ventilation grille Fig. 6 (3) into the cabinet base cut- out Fig. 6 (1) . u From the back side, slide the snap-fits Fig. 6 (2) into the grille until the hooks...

Page 8 - Installation; Water supply

u The total opening of the cabinet (i.e. 70-3/8 in. (1788 mm)) plus the thickness of the top as well as the floor board (usually 3/4 in. (19 mm)) minus the height of the freezer door panel (xxx in. (xxx mm)) as calculated above and subtract the width of the gap (approximately 1/8 in. (3 mm)): 70-3/8...

Page 9 - Assembling the appliance; Installation

Note u Before assembling the unit door, make sure that the permitted weight for the unit doors is not exceeded. u Otherwise damage to the hinges and malfunctions arising from this cannot be ruled out. Maximum weight of unit door Fridge compartment door 30.5 lbs (14 kg) Freezer compartment door 26.5 ...

Page 11 - Fitting the unit doors

u Slightly loosen the screws Fig. 20 (55) . u Secure the top mounting bracket Fig. 20 (50) to the unit wall with a ø4x19 chipboard screw Fig. 20 (29) . u Break off the protruding end of the cover Fig. 20 (53) . Fig. 20 u Tighten the screws Fig. 20 (55) . u Place the cover Fig. 20 (53) in position. O...

Page 13 - Connecting the appliance

7 Connecting the appliance WARNING Electrical shock hazard! u Start-up should only take place once the appliance has been installed according to these instructions. u Electrically ground appliance. u Do not ground to a gas pipe. u Check with a qualified electrician if you are not sure the appliance ...

Liebherr 20707 - Manual

Table of Contents:

Summary

Other Liebherr Models