La Crosse Technology WT-5120 433 - Manual
La Crosse Technology WT-5120 433 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Program Mode; Features & Operations
- Page 3 – Operation of these features is in section III
- Page 4 – Have the projection alarm and remote temperature sensor 3 to 5; remote temperature sensor; first then
- Page 5 – ALARM; Remove the battery cover.
- Page 8 – “SNOOZE”
- Page 9 – This temperature is displayed in; HUMIDITY; The sensor should not be mounted on a metal surface.
- Page 10 – CHANGING DISPLAY MODE (INDOOR TEMPERATURE/HUMIDITY OR ALARM TIME)
- Page 11 – The remote temperature sensor can be mounted in two ways:; MOUNTING WITH SCREWS; Where marked, start the screw holes into the mounting surface.; MOUNTING WITH ADHESIVE TAPE; Do not submerge in water.
- Page 12 – TROUBLESHOOTING
- Page 13 – SPECIFICATIONS FOR WT-5120; Every 10 seconds
- Page 14 – WARRANTY INFORMATION
WT-5120
433 MHz
Radio Controlled Projection Alarm
Instruction Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 TABLE OF CONTENTS Topic Page Inventory of Contents/ Additional Equipment 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery Installation 5 Program Mode Programming Sequence 6 Function Buttons 6 Manual Time Setting 6 Time Zone Setting 6-7 Daylight Saving Time (DST) Setting 7 Features...
3 INVENTORY OF CONTENTS 1) WT-5120 Alarm Clock 2) TX6U Remote temperature sensor 3) AC adapter/transformer 4) Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1) Two fresh 1.5V AA batteries (optional for projection alarm clock) 2) Two fresh 1.5V AA batteries (for remote temp...
4 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the projection alarm and remote temperature sensor 3 to 5 apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the remote temperature sensor first then into...
