La Crosse Technology WS-9021U - Manual

6 NOTE: Fog and mist will not harm your temperature sensor, but direct rain must be avoided. DETAILED SETUP GUIDE BATTERY INSTALLATION - When one Temperature sensor is being used 1. First, insert the batteries to the Temperature sensor (see “ Temperature sensor ” below). 2. Within 2 minutes of power...

7 TEMPERATURE SENSOR 1. Remove the Battery Cover. 2. Observing the correct polarity, install 2 “AA” Alkaline Batteries—make sure they do not spring free, or start-up problems may occur. 3. Replace the Battery Cover. WIRELESS TEMPERATURE STATION Note: After the batteries are installed, DO NOT press a...

8 1. Remove the Battery Cover on the back of the Wireless Temperature Station. 2. Observing the correct polarity, install 2 “AA” Alkaline Batteries. 3. Replace Battery Cover. Battery compartment Battery cover Sensor signal reception icon *

9 • *When the signal is successfully received by the Temperature Station, the icon will be switched on. (If not successful, the icon will not be shown in LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off). On the other hand, the short blinking of th...

10 TIME SETTING 1. After exiting the 12/24 Hour Setting , the hour will begin flashing in the time display. 2. Press and release the min/max/+ button to select the desired hour. Note: "PM" will appear to the left of the time display for PM hours. For AM hours, that area will remain blank. 3....

11 3. Press and release the min/max/+ button once more to return to the current temperatures. RESETTING THE MINIMUM AND MAXIMUM READINGS: User may reset the minimum and maximum temperature data to the current value by the following step: Press and hold the min/max/+ key for about 3 seconds to reset ...

13 successfully received. If this is not happen, user shall restart the setting up from step 1. NOTE: You must insert the batteries into the third sensor within 45 seconds of reception of the second sensor. IMPORTANT: Transmission problems will arise if the setting for multiple sensors is not follow...

15 ½ reduction typical of most obstructions. It is possible to receive a signal through these materials, however maximum range will be much less due to their tendency to absorb or reflect a much larger portion of the sensor’s signal . TEMPERATURE SENSOR The Temperature has been designed to be hanged...

16 To wall mount: 1. Remove the mounting bracket from the temperature sensor. 2. Mount using either screws or adhesive tape. 3. Reattach the temperature sensor to the mounting bracket. WIRELESS TEMPERATURE STATION 1. The Wireless Temperature Station comes with the table stand attached to the back of...

18 4) Using good quality alkaline batteries, place the batteries back into the outdoor temperature sensor; making sure they are installed according to the diagrams in the battery compartment. 5) Taking care not to press any buttons, reinstall the batteries in the Wireless Temperature Station accordi...

20 DIMENSION: (H x W x D) Receiver 2.76 x 1.14 x 4.54 in (70 x 29 x 115.2 mm) Temperature Sensor 1.50 x 0.83 x 5.05 in (38.2 x 21.2 x 128.3 mm) Battery life Up to 24 Months WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects...

23 This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information...