Page 3 - Figure 1: Weather station display unit
3 INVENTORY OF CONTENTS 1. Weather display unit 2. The outdoor temperature/humidity sensor (TX4U) 3. Instruction manual and warranty card ADDITIONAL EQUIPMENT (not included) 1. Five AA 1.5V batteries. Hint: USE a Good Quality Alkaline Batteries and avoid Rechargeable batteries Figure 1: Weather stat...
Page 4 - ABOUT WWVB; The NIST (National Institute of Standards and
4 ABOUT WWVB The NIST (National Institute of Standards and Technology—Time and Frequency Division) radio station, WWVB, is located in Ft. Collins, Colorado and transmits the exact time signal continuously throughout the United States at 60 kHz. The signal can be received up to 2 000 miles away throu...
Page 5 - Batteries out of both units for at least 10 minutes.; (All remote sensors must be started; before; the weather station); DO NOT PRESS ANY BUTTONS FOR 10 MINUTES
5 SET-UP GUIDE 1. Have the weather station and remote sensor 3 to 5 feet apart. 2. Batteries out of both units for at least 10 minutes. 3. Place the batteries into the remote sensor FIRST then place batteries into the weather station NEXT. (All remote sensors must be started before the weather stati...
Page 6 - PROGRAM MODE; If 20 seconds is allowed to pass during
6 I. PROGRAM MODE Programming Note: If 20 seconds is allowed to pass during programming modes the unit will confirm/set the last information entered, the display will stop flashing and return to normal time-date readings. Function Keys: NOTE: There are two methods by which the time can be set: • Aut...
Page 7 - Manually; SETTING THE LCD CONTRAST
7 Manually This is only necessary if you do not wish to wait for the WWVB reception. All manual set time and date settings will be over-ridden by the reception of the WWVB signal. In most cases all that needs to be set different from the default (factory) settings is the time zone (section “D” follo...
Page 8 - 2 OR 24 HOUR TIME SETTING; “12h” will be flashing in the time LCD.; SETTING THE HOUR AND MINUTES; The digit representing the hour should be flashing.
8 B. 12 OR 24 HOUR TIME SETTING 1. “12h” will be flashing in the time LCD. 2. Press and release the “CH/+” button to toggle between 12h (AM/PM) and 24h (military time). Note: in 12h mode “PM” will appear to the left of the time during the PM hours. If the time is not within the PM hour nothing will ...
Page 9 - TIME ZONE SETTING; –5 should be flashing in the time LCD
9 D. TIME ZONE SETTING 1. –5 should be flashing in the time LCD 2. Select your appropriate time zone by pressing and releasing the “CH/+” button. The time LCD displays the 3 letter abbreviations for the time zones found in North America along the very top of the display. Follow the chart below to fi...
Page 10 - SETTING THE YEAR; “2000” should be flashing in the time LCD.; SETTING THE MONTH/DAY; The number representing the day should be flashing.
10 2. Press and release the “CH/+” button to select the appropriate setting. 3. Press the “MODE/SET” button to confirm and advance to the year setting. F. SETTING THE YEAR 1. “2000” should be flashing in the time LCD. 2. Press and release the “CH/+” button to advance to the desired year. 3. Press an...
Page 11 - F should be flashing in the time LCD.
11 H. SELECTING ° F OR ° C 1. ° F should be flashing in the time LCD. 2. Press and release the “CH/+” button to select between ° F and ° C. 3. Press and release the “MODE/SET” button to confirm and advance to the weather forecast sensitivity setting. I. SETTING THE WEATHER FORECAST SENSITIVITY (hPa)...
Page 13 - The manual set up is now complete.
13 K. MANUALLY SETTING THE RELATIVE AIR PRESSURE 1. The numerals in the pressure LCD will now be flashing (only for relative air pressure) 2. Press and release the “CH/+” to increase the relative air pressure. Refer to your local weather service for an appropriate setting. 3. Press and release the “...
Page 14 - Sunny; not that the weather will be sunny; Sun with Clouds; not that the weather will be sunny with clouds; Clouds with rain; not that the weather will be rainy
14 II. FEATURES OF THE WS-7059SU A. WEATHER FORECAST The weather forecast feature is estimated to be 75% accurate. By adjusting the sensitivity setting you can achieve a better accuracy of forecast. The weather forecast is based solely upon the change of air pressure over time. In areas where the we...
Page 16 - The air pressure history is taken every hour by; INDOOR TEMPERATURE AND HUMIDITY; When you are done viewing the minimum or
16 the graph than the left) then the air pressure has a falling trend, and the weather should worsen. Note: The air pressure history is taken every hour by averaging the last 11 readings (taken every minute). E. INDOOR TEMPERATURE AND HUMIDITY The current indoor temperature and humidity is displayed...
Page 18 - OUTDOOR REMOTE CONTROL SENSORS; When setting up multiple units it is important to insert; VIEWING AND OPERATING WITH MULTIPLE
18 III. OUTDOOR REMOTE CONTROL SENSORS TX4U included (others are optional) The WS-7059SU is able to receive signals from 3 different remote sensors. When the TX4U and/or other units are set up the indoor LCD will display the remote sensors when the “IN/OUT” button is pressed. The weather station wil...
Page 19 - MOUNTING; Before permanently mounting ensure that the weather; The Weather Station
19 3. To view the minimum and maximum temperature select which remote sensor to read data from and then press and release the “MIN/MAX/RESET” button. 4. Pressing this button once will display the minimum temperature, minimum humidity and the date and time the data was recorded. Pressing this button ...
Page 20 - The TX4U Remote Sensor
20 B. The TX4U Remote Sensor 1. Mounting with screws a. Remove the mounting bracket/ receptor from the packaging. b. Place the mounting bracket over the desired mounting surface. Through the 2 screw holes of the bracket, mark the mounting surface with a pencil. c. Where marked start screw holes usin...
Page 21 - TROUBLESHOOTING
21 II. TROUBLESHOOTING Problem: No reception of WWVB time signal Solution: 1) Wait overnight for signal. 2) Be sure Weather Station is at least 6 feet from any electrical devices, such as televisions, computers, or other radio-controlled clocks. 3) Remove batteries for five minutes, reinsert and lea...
Page 22 - MAINTENANCE AND CARE INSTRUCTIONS; Do not submerge in water.
22 III. MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • Do not submerge in water. • I...
Page 23 - SPECIFICATIONS; WWVB; Recommended operating temperature:; levels; Temperature measuring range:; C with
23 IV. SPECIFICATIONS Radio controlled time signal: WWVB Recommended operating temperature: Weather Station: 32 ° F to 122 ° F (0 ° C to 50 ° C) Remote Sensor: -25 ° F to +158 ° F LCD contrast: 8 levels Temperature measuring range: Indoor: 32 ° F to 122 ° F with 0.2 ° F resolution. (0 ° C to 50 ° C ...
Page 24 - Data checking intervals:; Every 10 seconds
24 Air pressure: Absolute inHg: 20.67 inHg to 32.45 inHg Relative hPa (optional): 970 hPa to 1030 hPa Relative inHg (optional): 28.60 inHg to 30.45 inHg Sensitivity setting hPa: 2,3, and 4 hPa Air pressure history: For the past 72 hours at –72, -48,-36, -24, -18, -12, -9, -6, -3, -1, and 0. Data che...
Page 25 - WARRANTY INFORMATION
25 WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to th...
Page 26 - La Crosse Technology
26 the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Techn...
