La Crosse Technology WS-6118 - Manual
La Crosse Technology WS-6118 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – “SET”; FUNCTION KEYS
- Page 5 – 33MHz RECEPTION CHECK FOR OUTDOOR TEMPERATURE TRANSMITTER; transmission problems may occur.; Setting up; To change the display:; WWVB RADIO CONTROLLED TIME; Manual time setting
- Page 6 – MOON PHASE; FullMoon; POSITIONING
- Page 7 – MOUNTING WITH ADHESIVE TAPE; TROUBLESHOOTING
- Page 8 – LIABILITY DISCLAIMER:
- Page 9 – Or visit us on the internet at; THAT MAY CAUSE UNDESIRED OPERATION.
WS-6118
ATOMIC CLOCK WITH OUTDOOR WIRELESS TEMPERATURE AND
MOON PHASE
Instruction Manual
FEATURES:
ATOMIC CLOCK:
•
WWVB Radio controlled time with manual time setting
•
12/24 hour time display
•
Time display: hour, minute, second
•
Alarm setting with snooze function
•
Calendar
display
•
Weekday display (3 languages to choose from: English, French and Spanish)
•
Time zone setting
•
Daylight savings time ON/OFF option (DST)
•
ºC or ºF temperature display selectable
•
Indoor temperature display
•
Outdoor temperature display via 433MHz transmission
•
Wall mount or freestanding
•
Current moon phase display
OUTDOOR TEMPERATURE TRANSMITTER:
•
Remote transmission of outdoor temperature to the atomic clock by 433 MHz signals
•
Wall mounting case
TO INSTALL AND REPLACE BATTERIES IN THE ATOMIC CLOCK
The atomic clock uses 2 x AA, 1.5V batteries. To install and replace the batteries, please follow the
steps below:
1.
Insert finger or other solid object in the space at the bottom center of the battery compartment
and lift up to remove the cover.
2.
Insert batteries observing the correct polarity (see marking inside battery compartment).
3.
Replace compartment cover.
DO NOT SET THE CLOCK.
TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow the
steps below:
1.
Remove the cover.
2.
Insert the batteries, observing the correct polarity (see marking inside battery compartment).
3.
Replace the battery cover on the unit.
Alkaline batteries are recommended for use in both units. Avoid using rechargable batteries.
SETTING UP:
Holder
LCD2
display
Battery cover
Function keys
LCD1
display
Hanging holes
Foldable stand
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Alkaline batteries are recommended for use in both units. Avoid using rechargable batteries. NOTE: Do not set the clock until the outdoor temperature is displayed. 1. Place batteries in the outdoor transmitter first, then into the atomic clock. DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. 2. After the 1...
433MHz RECEPTION CHECK FOR OUTDOOR TEMPERATURE TRANSMITTER The atomic clock will receive the temperature data within 4 minutes. If the temperature data is not being received 4 minutes after setting up (the display shows “- - -”), then please check the following points: 1. The distance of the atomic ...
MOON PHASE The Moon Phases, and their corresponding dates appear in LCD 2. There are 12 visible Moon Phases that will show in the LCD 2: MOON PHASES FOR WS-8117 New Moon Small Waxing Large Waxing First Quarter Small Waxing Large Waxing Crescent Crescent Gibbous Gibbous FullMoon Large Waning Small Wa...
