La Crosse Technology TX7U - Manual
La Crosse Technology TX7U – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MOUNTING WITH THE SCREWS
- Page 3 – Do not submerge in water.
- Page 4 – DISCLAIMER; This product is not a toy. Keep out of children’s reach.; WARRANTY INFORMATION
- Page 5 – La Crosse Technology; FCC DISCLAIMER; interference that may cause undesired operation.
TX7U Outdoor Temperature/Humidity Sensor
The TX7U outdoor temperature/humidity sensor can be added to your existing
units in operation. The outdoor temperature/humidity sensor measures the
outdoor temperature and humidity (or any other location you wish to know the
temperature and humidity) and transmits the data to the indoor display station.
INVENTORY OF CONTENTS
1.
Outdoor temperature/humidity sensor.
2. Mounting
bracket.
3. Rain
protector.
4.
Two each, ½” Philips mounting screws.
5.
One strip double sided adhesive tape.
6.
Instruction manual and warranty return card.
ADDITIONAL EQUIPMENT
(not included)
1.
One Philips screwdriver.
2.
One Flat screwdriver.
3.
Two fresh AA 1.5V batteries.
I. SETTING UP
Before you begin, assign a number to each outdoor temperature/humidity sensor
(i.e. #1 for outdoors, #2 for the basement, etc.) if you have multiple sensors. This
will help you determine which temperature, from which outdoor
temperature/humidity sensor, you are reading on the indoor display station.
Note:
Remove batteries from all existing units in operation—including outdoor
temperature/humidity sensor units and indoor display stations. When setting up
multiple units it is important to insert batteries
first
into all the outdoor
temperature/humidity sensors, and in numeric sequence.
Second
install batteries
into the indoor display station. Transmission problems will arise if this is not done
correctly and if the total time for setup exceeds 6 minutes.
A. BATTERY
INSTALLATION
Follow these directions when first setting up, when replacing batteries,
or for resetting purposes.
1.
Remove the batteries from all existing display units in operation.
2.
Using a screwdriver, unscrew and open the battery cover located
at the front of the outdoor temperature/humidity sensor.
Outdoor
temperature/humidity
sensor
Mounting Bracket
Battery cover
Battery
compartment
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Note: Outdoor temperature/humidity sensors will not usually read the same temperature. This is due to variants such as drafts and handling. This is normal. 3. Observe the correct polarity and install 2 AA alkaline batteries in each unit in sequential order. The batteries will fit tightly—make sure t...
5. Snap the outdoor temperature/humidity sensor into place on the mounting bracket. B. MOUNTING WITH ADHESIVE TAPE 1. With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2. Remov...
V. LIABILITY DISCLAIMER 1. The manufacturer and supplier cannot accept any responsibility for any incorrect readings and any consequences occurring should an inaccurate reading take place. 2. This product is not to be used for medical purposes or for public information. 3. The specifications of this...
