La Crosse Technology WS-7212U - Manual
La Crosse Technology WS-7212U – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Notes on Outdoor Sensor Placement; “SET”; BATTERY INSTALLATION; INDOOR WEATHER STATIONS
- Page 3 – MINIMUM AND MAXIMUM TEMPERATURES; ADDING ADDITIONAL REMOTE TEMP/HUMIDITY SENSORS
- Page 4 – VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS; “CH”; REMOTE TEMP/HUMIDITY SENSOR
- Page 5 – Temperatures do not match if units are placed next to each other.
- Page 7 – FCC DISCLAIMER
WS-7212U Wireless 433 MHz Weather Station
Instruction Manual
INVENTORY OF CONTENTS
1.
Two indoor weather stations (Figure 1)
2.
The remote temperature/humidity sensor (TX4U) and mounting bracket. (Figure 2)
3.
Mounting hardware.
4.
Instruction Manual and Warranty Card.
Figure 2
Figure 1
ADDITIONAL EQUIPMENT
(not included)
1.
1 Philips screwdriver.
2.
4 Fresh AA 1.5V batteries.
(2 for each indoor weather station)
3.
2 Fresh AA 1.5V batteries.
(for temp/humidity sensor)
QUICK SETUP
Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1. Have the indoor weather stations and remote temp/humidity sensor 3 to 5 feet apart.
2. Batteries should be out of all units for 10 minutes.
3. Place the batteries into the
remote temp/humidity sensor
first, then into the
indoor weather stations
.
(All remote temp/humidity sensors must be started before the indoor weather stations)
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the indoor weather stations and remote temp/humidity sensor will start to talk to each other and the displays
will show both the indoor temperature and an outdoor temperature and humidity. If the indoor weather stations do not
display both the indoor temperature and the outdoor temperature and humidity after the 15 minutes please retry the set
up as shown on page five.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
After both indoor temperature and outdoor temperature and humidity are displayed for 10 minutes you can place your remote temp/humidity sensor outdoors and set your time. Notes on Outdoor Sensor Placement The remote temp/humidity sensor should be placed in a dry, shaded area. Fog and mist will not h...
SETTING THE TIME 6. Press and hold the “ SET” button for 5 seconds. 7. The hour will begin to flash. 8. Press and release the “ +” button to advance the hour to your desired hour. 9. Press and release the “SET” button to move to the minute setting. 10. The minutes will begin to flash. 11. Press and ...
D. VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS 1. To view the temperature of a different remote sensor unit, press and release the “CH” button. A shift from one “boxed” number to the next should be observed in the OUTDOOR LCD. 2. To view the Minimum/Maximum temperature: first select from...
