Page 2 - I NT R O D UC T I O N
P a g e | 2 I NT R O D UC T I O N ongratulations on purchasing this state-of-the-art weather station. Featuring time, date, weather forecast, wind gust and wind speed, indoor/outdoor temperature and humidity, air pressure and rainfall, this weather station will provide various weather information an...
Page 5 - I NV E NT O R Y O F C O NT E NT S; Wind Sensor; Do Not Discard; Enables wireless computer
P a g e | 5 I NV E NT O R Y O F C O NT E NT S Carefully open the package and check that the following contents are complete: Wind Sensor Rain Sensor Thermo-Hygro Sensor Wireless Display USB Transceiver Mast holder Right angle adaptor 1 x U-bolts 2 Washers + 2 Nuts Plastic Reset Rod Base ...
Page 6 - F E AT U R E S; W I R E L E S S D I S P L A Y W S - 2 8 1 4 U - I T
P a g e | 6 F E AT U R E S W I R E L E S S D I S P L A Y W S - 2 8 1 4 U - I T Weather station works with or without a computer • 12/24 hr. time & calendar with date, month & year • Manual time (without PC computer) or automatic time/date when using USB transceiver to sync to PC time/date • ...
Page 7 - Supported operating systems:
P a g e | 7 W I R E L E S S S O L A R P OW E R E D W I N D S E NS O R ( T X 6 3 U - I T ) • 100% solar-powered (built-in power cell, no batteries necessary) • High-efficiency solar panels maintain operation in every season • 200 Ft. wireless range (free of obstructions) • 9.84" L x 5.74" W x...
Page 8 - S E T UP I NS T R UC T I O NS S T E P B Y S T E P; solar panel. Remove the tape covering the reset hole.; “Manual Settings”
P a g e | 8 Press Reset Button on Bottom of W ind Sensor (Solar Panel Must Face Light) S E T UP I NS T R UC T I O NS S T E P B Y S T E P IMPORTANT: Make sure to observe the correct polarity when inserting batteries. The "+" markings on the batteries must line up with the diagrams inside the ...
Page 9 - SETUP TROUBLESHOOTING:
P a g e | 9 SETUP TROUBLESHOOTING: If the sensor data fails to display for any of the outdoor sensors within 10 minutes, (“- - -“are displayed), remove the batteries from all units for 1 minute and start the Setup procedure again at Step 1. F U N C T I O N B UT T O NS S E T Hold for 3 seconds to e...
Page 10 - Stop the alarm when the time alarm or weather alarm rings; L C D S C R E E N
P a g e | 10 Stop the alarm when the time alarm or weather alarm rings Press to exit max/ min record display mode Stop the weather alarm when ringing M I N / MA X Press to display minimum and maximum records of various weather data Stop the weather alarm when ringing L C D S C R E E N When...
Page 11 - MANUAL TIME
P a g e | 11 10. Weather tendency threshold value 11. Storm warning threshold value 12. Alarm On/ Off setting 13. Wind direction display type 14. Factory Reset L C D C O N T R A S T S E T The LCD contrast can be set within 8 levels; from "Lcd 1" to "Lcd 8" (default setting is "Lc...
Page 14 - SEE WARNINGS
P a g e | 14 S T O R M A L A R M O N / O F F S E T : The storm warning display (flashing downward weather tendency arrow) can be accompanied by a ring of the alarm. Switch the acoustic storm warning alarm On (AON) or Off (AOFF) (Default OFF). 1. The digit "AOFF" will flash. 2. Press the ▲/DA...
Page 15 - W E AT HE R AL AR M O P E R AT I O NS F O R T H E W E AT HE R S T AT I O N D I S P L AY
P a g e | 15 4. After waiting for 10 minutes, insert the batteries into the thermo-hygro sensor, and rain sensor making sure to align the "+" symbol on the batteries with the markings on the battery cover and inside the battery compartment. 5. Within 2 minutes of inserting the batteries into...
Page 16 - Pressure
P a g e | 16 D E F A U L T W E A T H E R A L A R M V A L U E S : Pressure Low 28.35 inHg Wind gust High 62.0mph High 30.71 inHg Wind Direction North Temperature (In or Out) Low 32 F Rainfall in 24 hours High 1.96 in High 104 F Relative Humidity (In or Out) Low 45% High 70% P R E S S U R E A L A ...
Page 17 - indoor humidity
P a g e | 17 6. Press the ALARM button once. The low outdoor temperature alarm display will be shown. 7. Press and hold the SET button for about 2 seconds. The temperature digit will flash. 8. Press the ▲/DATE button or ▼/RAIN button to set the low indoor temp alarm value. Hold the arrow button in t...
Page 18 - outdoor humidity alarm
P a g e | 18 8. Press the ▲/DATE button or ▼/RAIN button to set the low outdoor temp alarm value. Hold the arrow button in to change the value faster. 9. Press the ALARM button to confirm the setting. The digit will flash. 10. Press the SET button to switch the alarm on or off. The ((( ))) icon in...
Page 19 - 4-hour rainfall alarm
P a g e | 19 4. Press the SET button to set a wind direction alarm value. A pointer icon will appear inside of the compass circle to indicate an alarm setting for that wind direction. 5. To remove an alarm setting for a wind direction, press the SET button again to remove the selected wind direction...
Page 20 - D I S P L AY MO D E S
P a g e | 20 D I S P L AY MO D E S MO D E 1 Press and release the SET button to toggle between Mode 1 and Mode 2 display: Pressure history graph displays 24 hour history Outdoor temperature displayed in the outdoor section Wind speed displayed in the wind section MO D E 2 Press and release the...
Page 21 - check in the setting mode; WEATHER TENDENCY SENSITIVITY; in the manual settings; arrows located on
P a g e | 21 check in the setting mode –see WEATHER TENDENCY SENSITIVITY in the manual settings above. The displayed icon forecasts the weather in terms of getting better or worse and not necessarily sunny or rainy as each icon indicates. For example, if the current weather is cloudy and the rainy i...
Page 22 - W I N D D I R E C T I O N AN D W I N D S P E E D ME A S UR E ME N T
P a g e | 22 The vertical bars are plotted at each of the seven steps and give the trend over the recorded period. The 0 hour vertical bar will always display at the midline height to indicate the current air pressure. The varying height of bars in other columns on the graph indicates a relative cha...
Page 23 - R AI N F AL L ME AS UR E ME NT
P a g e | 23 R AI N F AL L ME AS UR E ME NT The 1hour, 24-hour, week, month or total rainfall measurement is displayed on the LCD, in the unit of inch or mm. For all measurements, it is important time and date are set correctly on your display. 1-HOUR RAIN: The 1-hour rain reflects rain that has f...
Page 24 - C O M MO N T E R MS :; wind gust
P a g e | 24 R E S E T T O T A L R A I N F A L L A MO U N T The total rainfall measurement is displayed in the unit of mm or inch. It shows the total rainfall accumulated since last reset of the total rainfall amount. In either Mode 1 or Mode 2 display, press and release the MIN/MAX button until the...
Page 25 - MO U NT I NG AN D P L AC E ME NT O F S E NS O R S AND D I S P L AY
P a g e | 25 MO U NT I NG AN D P L AC E ME NT O F S E NS O R S AND D I S P L AY IMPORTANT: Ensure that all of the sensor data can be received at the intended mounting locations before you drill mounting holes. The outdoor sensors have a wireless range of 200- feet . Keep in mind that the 200-foot ra...
Page 26 - with the front of the sensor (the solar panel) facing true
P a g e | 26 W I N D S E N S O R The wind sensor must be installed with the front of the sensor (the solar panel) facing true South , or the reported wind direction will not be accurate. Mount within the 200-foot wireless range of the thermo-hygro sensor and on the same side of the house. The roof...
Page 27 - not
P a g e | 27 T H E R MO - H Y G R O S E N S O R The thermo-hygro sensor is "weather resistant", but not "water proof". To ensure an extended life for the sensor, mount it in a semi-covered place out of the elements at a minimum height of 6 feet. An ideal location for the thermo-h...
Page 28 - S P E C I F I C AT I O NS
P a g e | 28 S P E C I F I C AT I O NS I N D O O R T E MP E R A T U R E 41°F to 104°F (5°C to 40°C) ( “OF.L” displayed if outside this range) I N D O O R H U M I D I T Y 3% to 99% ( “- -” displayed if < 1%, "99" displayed if 99%) O U T D O O R T E MP E R A T U R E / D E W P O I N T -40°...
Page 30 - C AR E AN D M AI NT E N AN C E
P a g e | 30 C AR E AN D M AI NT E N AN C E Do Not Mix Old and New Batteries Do Not Mix Alkaline, Lithium, Standard, or Rechargeable Batteries Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate forecasts and readings. Precaut...
Page 31 - F C C S T AT E ME NT; This device may not cause harmful interference.; W AR R AN T Y I NF O R M AT I O N
P a g e | 31 F C C S T AT E ME NT Statement according to FCC part 15.19: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including inte...
Page 32 - La Crosse Technology, Ltd
P a g e | 32 The La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (c...
