La Crosse Technology TX62U-IT - Manual
La Crosse Technology TX62U-IT – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The outdoor temperature will show on the weather station; WARNING
- Page 4 – NOTE
- Page 6 – WALL MOUNTING; —leaving approximately 3/16 of an; TO REPLACE BATTERIES IN THE WEATHER STATION; marking inside battery compartment or on the case).
- Page 7 – OR
- Page 8 – Power Requirements:
- Page 9 – La Crosse Technology
1
Model WS-8120U-IT
Solar Powered Wireless Temperature Station
INSTRUCTION MANUAL
Model TX62U-IT/Solar-powered Transmitter (Sensor):
LCD shows temperature readings
Transmits outdoor temperature to indoor receiver using 915 MHz
signals
200 FT. wireless transmission range (open air)
Built-in rechargeable alkaline power cells store solar power for
continuous operation
No batteries necessary (internal power cells cannot be replaced;
contact customer service for a replacement sensor)
Able to charge in low light environments.
Solar panel
Function
keys
Battery cover
Wall mount
Stands
LCD display
Solar panels
%
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 BATTERY COMPARTMENT INITIAL SETUP (USING INCLUDED SOLAR RECHARGEABLE BATTERIES FROM THE FACTORY) 1. Open battery compartment on the back of the Weather Station and make sure that the battery switch under the battery compartment is to the left. If it is not, please slide the switch to the left befo...
4 PROGRAM MENU: SET THE TIME: Press and hold the SET button for 3 seconds to enter the time setting mode. HOUR : The Hour digits will flash. Press and release the PLUS button to set the Hour. Press and release the SET button once. MINUTES : The Minute digits will flash. Press and release the PLU...
6 WALL MOUNTING 1. Install a mounting screw (not included) into a wall —leaving approximately 3/16 of an inch (5mm) extended from the wall. 2. Place the Weather Station onto the screw, using the hanging hole on the backside. Gently pull the Weather Station down to lock the screw into place. NOTE: Al...
