KTI Networks KGS-2401 - Manual

-10- 3. Installing 24-Port Gigabit Web Smart Switch This switch can be placed directly on your desktop, or mounted in a rack. Users can immediately usemost of the features simply by attaching the cables and turning the power on. 2.1 Desktop Installation For desktop installation, the switch needs to ...

-12- 4. Functional Description 4.1 PHY Monitoring and Port Mode Set-up It is a major task of the software to continuously monitor the PHYs in order to set up the switch portsaccording to whether the link is down or up and in the latter case what the current speed, duplex modeand pause capabilities a...

-13- 5. Web Management guide This section instructs you how to enter and set up the configurations, which can be accessed by RS-232 serial port (out-of-band) on the rear panel or by Internet Browser over the network (in-band). Factory Default value: IP : 192.168.1.1 Subnet Mask: 255.255.255.0 Defaul...

-16- 5.2.1 System To set up the system configurations such as login value, time-out value and enabling the VLAN Man-agement. Status & Setting Functions Mac Address The Mac Address of the switch S/W Version To check up the Software Version, see this. H/W Version The Hardware version Inactivity Ti...

-26- 6. Product Specifications Standard IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX IEEE802.3x full-duplex operation and flow control IEEE802.3ab 1000BASE-T IEEE802.1Q VLAN interoperability Interface 24 * 10/100/1000Mbps auto MDI/MDI-X RJ-45 switching ports 1 * RS-232 Console port Cable Connections RJ-...

-27- 7. Command Line Interface 7.1 Start-up and Terminal configuration To start-up the command line interface, connect a PC COM port to the RS-232 connector and activatea terminal emulation software (e.g. HyperTerminal of Windows.). The terminal emulation softwareshould be set up as follows: 1. Data...

-29- 7.5 Entering Commands Commands are given by entering the command string. The command string is not case-sensitive. There are three possible situations for entering the command: 1. At any level or group: you should enter the full syntax of the command with a / in front of the syntax (ex, enter /...

-30- 7.6 Terminology The following table shows general parameter types used in command syntaxes and descriptions. <port> The port number <portlist> Comma and/or dash separated port list. This type can be used for specifyingindividual ports or a range of ports. The keyword none can be use...

-41- 8. Factory Default Configuration The factory default configuration is a VLAN aware L2 switch with automatic learning/ageing and autonegotiation enabled on all ports: System: The system name string is empty. Console: The password string is empty and inactivity timeout is disabled. The prompt is ...