Kidde KN-COEG-3 (900-01 13) - Manual

Page 2 - Carbon Monoxide Alarm Procedure; Immediately move to fresh air - outdoors or by an open; Activation of the CO; What to do When the Alarm Sounds!

Carbon Monoxide Alarm Procedure 1) Operate the Test/Reset button; 2) Call your emergency services (Fire Department or 911); 3) Immediately move to fresh air - outdoors or by an open door/window. Do a head count to check that all persons areaccounted for. Do not reenter the premises nor move awayfrom...

Page 3 - Gas; Alarm Procedure; If the unit alarms for gas:; Activation of the Gas

Gas Alarm Procedure When the unit senses either natural gas or propane, the display willshow “GAS” and emit a loud alarm pattern. The alarm pattern for gasis a 1/2 second beep followed by a 1/2 second of silence then repeat-ing. Know how to respond to a CO or gas emergency. If the unit alarms for ga...

Page 6 - Information About Carbon Monoxide

General Carbon Monoxide Information CO is a colorless, odorless and tasteless poison gas that can be fatalwhen inhaled. CO inhibits the blood’s capacity to carry oxygen. Periodically review this alarm manual and discuss your CO alarm emer-gency procedure with all the members of your family. Never ig...

Page 7 - Possible Sources of Carbon Monoxide; • Blocked chimneys or flues, back drafts and changes in air pressure,; Conditions That Can Produce Carbon Monoxide; The following conditions can result in transient CO situations:

See “What to do When the Alarm Sounds” (inside front cover). High Levels: Generally above 100 PPM, with no one experiencing symptoms. Thisshould be treated as an urgent situation. See “What to do When theAlarm Sounds” (inside front cover). Mid Levels: Generally between 50 PPM to 100 PPM. This should...

Page 9 - General Information About Explosive Gas:

This CO alarm is designed to act as a monitor; it is not designed for useas a short-term testing device to perform a quick check for the presenceof CO. CO alarms have limitations. Like any other electronic device, CO alarmsare not fool-proof. CO alarms have a limited operational life. You musttest y...

Page 10 - Product Features and Specifications; with digital display

2. Product Features and Specifications BlinkingRed Dot Digital Display Carbon Monoxide ALARM Explosive Gas ALARM Test/Reset Button Peak Level Button Back Door Key Holes Slide Support for Table Top and Direct Plug Use Adapter Thumb Release Removable AC Adapter Cord Recess Power Cord Sounder Alarm 9V ...

Page 11 - Electrochemical; Accuracy of Digital Display:

2. Product Features and Specifications IMPORTANT: Seven (7) years after the initial power up, this alarmwill “beep” two times every 30 seconds to indicate that it is timeto replace the alarm. Replace the alarm immediately! It will notdetect CO in this condition. To help identify the date to replace ...

Page 12 - Installation Locations

Recommended Installation Locations CO and Gas alarms should bemounted in or near bedrooms andliving areas. It is recommended thatyou install a CO and Gas alarm oneach level of your home. When choosing your installationlocations, make sure you can hearthe alarm from all sleeping areas. Ifyou install ...

Page 13 - Installation Instructions

How to Install Your Alarm Your Kidde CO and Gas alarm with its removable adapter allows you toinstall the alarm as a wall mounted unit, a direct plug unit, or as a tabletop unit. Direct Plug Alarm In its “as shipped” configuration, all you needto do is install the 9V backup battery and yourKidde CO ...

Page 14 - Wall Mounted Alarm

2. Spread adapter thumb releases out and carefully turn alarm over. This will allowadapter to slide out. 3. Lift the adapter completely out of the alarm and rotate the adapter 90˚ to the right(clockwise). Snap it firmly back into place. 4. Carefully replace the back door. Insure the “latches” on all...

Page 15 - Alarm Characteristics; Carbon Monoxide Alarm Indicator; Hook the unit over the screw head and into the key-; Table Top Alarm

5. Alarm Characteristics Carbon Monoxide Alarm Indicator This CO and Gas alarm is designed to act as a monitor. It is notdesigned for use as a short term testing device to perform a quick checkfor the presence of CO or gas. When the alarm senses a dangerous level of CO, the unit will emit aloud alar...

Page 17 - Operating and Alarm Characteristics

If the battery is low or missing, or if the unit malfunctions, it will displayother readings (and alarm differently) to alert you of specific conditions.Please familiarize yourself, and other family members, to the differencebetween a CO reading and and indication signifying a problem with theunit i...

Page 19 - This unit is sealed. The cover is not removable.; Testing; press the Test/Reset button. If the alarm is operating; Battery Replacement

7. Maintenance NOTE: This unit is sealed. The cover is not removable. Due to the loudness of the alarm, we suggest that you place yourfingers over the sounder opening while testing your alarm. CAUTION: Continuous exposure to the high sound level of thisalarm over an extended period of time may cause...

Page 20 - Maintenance Tips

7. Maintenance These batteries can be purchased where you bought the alarm or at alocal hardware store. Use of a different battery may have a detrimentaleffect on the alarm operation. The 9 volt battery is not rechargeable. If the 9 volt battery is missing,disconnected, or if the battery’s power is ...

Page 22 - FIVE YEAR LIMITED WARRANTY; QUESTIONS OR FOR MORE INFORMATION

FIVE YEAR LIMITED WARRANTY Warranty Coverage: The manufacturer warrants to the original consumer purchaser, that this product (except battery) will be free of defects in material and workmanship for a periodof five (5) years from date of purchase. The manufacturer’s liability hereunder is limited to...

Kidde KN-COEG-3 (900-01 13) - Manual

Table of Contents:

Summary

Other Kidde Models