Keys Fitness 7.3t - Manual

Assembly The Triumph 7.3t Treadmill will require assembly before operating. After opening the box, remove any packing material from the treadmill. Do not throw away any packing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electrical cord will ...

Assembly Assembly requires the included allen wrench and phillips screwdriver. Do not plug in the power cord until all assembly steps are completed. 6 Figure 1: Console Harness Location Figure 2: Console Harness Connection 1. With the treadmill deck in the downposition, leave the unit on the origina...

Assembly 7 Figure 3: Left and Right Upright Installation Figure 4: Console Installation 4. Install the Left and Right Uprights to the tread-mill base frame by inserting the upright connect-ing bracket into base frame as seen in Figure 3,using Allen Bolt 5/16”-18 x 70 (Qty. 4), SpringWasher 8 mm (Qty...

Assembly 8 7. Position the Left and Right Bottom HandleCovers to underside of handle assembly, thenconnect the EKG Harness Wires to the Left andRight Bottom Handle Pulse Plates as shown inFigure 5.Tighten into place using Phillip Screw ST4.2X16(Qty. 6).Next, install the End Caps to the handle assem-...

Assembly 9 9. Install the Left and Right Fender to Base usingPhilip Screw ST4.2X16 as shown in Figure 7. 10. Install the Long Bumper (Qty 2) to Baseusing Allen Bolt M8*30 (Qty. 2) as shown in fig-ure 8. Figure 7: Left and Right Fender Installation Figure 8: Long Bumper Installation BASE BASE LEFT FE...

Warm Up Exercises TOE TOUCH STRETCH Stand, bending your knees slightly and slowly bend forward from your hips.Allow your back and shoulders to relax as you reach down toward your toesas far as possible. Hold for 15 counts, then relax. This will stretch your ham-strings, back of knees, and back. HAMS...

Moving Instructions CAUTION! TO AVOID THE RISK OF INJURY, NEVER ATTEMPT TO MOVE THE TREADMILL WHILEIT IS IN THE UNFOLDED OPERATING POSITION. TO REDUCE THE POSSIBILITY OF INJURYWHILE LIFTING, BEND YOUR LEGS AND KEEP YOUR BACK STRAIGHT. AS YOU RAISE THETREADMILL, LIFT USING YOUR LEGS, NOT YOUR BACK. I...

Power Requirements I M P R O P E R C O N N E C T I O N O F T H E E Q U I P M E N T G R O U N D I N G C O N N E C TO R C A N R E S U LT I N A R I S K O F A N E L E C T R I C S H O C K . C H E C K W I T H A Q U A L I F I E D E L E C T R I C I A N O RS E RV I C E M A N I F Y O U A R E I N D O U B T A S...

Console Panel Functions There are five display windows on the control panel to provide feedback information. TIME / PACE WINDOW TIME: Indicates elapsed time after pressing start in minutes and seconds (0-99 minutes, 0-59 seconds) PACE: Indicates countdown in seconds to the next interval starting at ...

QUICK START / MANUAL MODE 1. Plug into a surge protector outlet. Attach the Safety Key on to the treadmill console. 2. Stand on the treadmill and straddle belt. Attach safety key clip to your clothes.3. Press POWER button. There will be an eight (8) second delay after pressing the POWER button befor...

Program and Operation PROGRAM MODE Plug treadmill into a surge protector outlet. Attach the Safety Key on to the treadmill console. 1. Stand on the treadmill and straddle belt. Attach safety key clip to your clothes. 2. Press POWER button. There will be an eight (8) second delay before data can be e...

Program Profiles 16 The Fat Burn Program is designed to vary the treadmillelevation, while maintaining aconstant walking belt speed. The Cardio Program is designed to vary the treadmillSpeed, while maintaining a con-stant Elevation. The Warm Up Program is designed to gradually increase the treadmill...

Belt Adjustment WARNING! Do not over-tighten rollers! This will cause prema-ture roller bearing failure! Belt adjustment and tension performs two functions: adjustment fortension and centering. Your new treadmill comes pre-adjusted fromthe factory for tension and centering. Please follow the procedu...

Change MPH to KMH Your treadmill will operate in British Units (miles per hour) or International Units (kilometers per hour). Alltreadmills are calibrated at the factory for British Units (miles per hour). To change the display to read in kilo-meters, follow the steps described here: 1) Turn power O...

Maintenance Instructions WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from the surge protector. CLEANING: Routine cleaning of your Triumph 7.3t Treadmill will extend the life of your unit. WARNING! To prevent electrical shock, be sure the power to the tr...

Troubleshooting Guide Treadmill will not start . 1. Is the Safety Key inserted into the treadmill Console? 2. Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet, and the surge protector is turned on. (Refer to “Power Requirement...

Error Messages Treadmill Error Messages . Your treadmill is equipped with a software package that enables error messages to be displayed when there isa problem. The following error codes will be displayed in the console display windows. Safety Interlock Error Messages SI 1 - Safety key missing, repl...

Calibration Sequence Do not attempt to calibrate the treadmill unless an Error Code is present. See Error Messages (page 21). Our treadmill is equipped with a software package that will perform a calibration sequence unique to yourspecific model number.Please perform the following steps to calibrate...

Parts List REF# KEYS PART# DESCRIPTION QTY. REF# KEYS PART# DESCRIPTION QTY. 1 423-00008 Cross Bar 1 54 402-00046 Clip Nut 8 2 406-00055 Base Bumper 2 55 406-00099 Transport Wheel, Clear 2 3 406-00056 Long Bumper 2 56 404-00004 Poly V-Belt 190J8 1 4 423-00009 Left Upright 1 57 404-00008 Walkbelt, Tr...

Warranty Information 27 Keys Triumph 7.3t Treadmill KEYS FITNESS PRODUCTS, LP – LIMITED WARRANTY PLEASE CONSULT YOUR PHYSICIAN BEFORE USING THIS PRODUCT. This Limited Warranty applies in the United States and Canada to products manufactured or distributed by Keys Fitness Products, LP (“Keys”) under ...