Kenmore BU3040 - User Manual

- 5 - VACUUM CLEANER WARRANTY LIMITED WARRANTY FOR ONE YEAR from the date of sale this product is warranted against defects in material or workmanship. WITH PROOF OF SALE a defective product will be replaced free of charge. The Kenmore brand is used under license. Direct all claims for warranty serv...

- 7 - Che ck Bag I ndicator PARTS AND FEATURES Handle Upper Hose Connection Flexible Hose Suction Control Lower Hose Connection Hose Release Button Lower Cord Hook Hose Storage Carrying HandleDust Bag Chamber Cover ReleaseDust Bag Chamber Cover (Dust Bag Inside) Exhaust Filter Cover (HEPA Media Exha...

- 8 - Lower Hose Connection Lower Cord Hook Upper Cord Hook 1. Insert the handle into the main body until you hear a ‘click’. 2. Insert the right-angle end of the flexible hose into the main body as shown until you hear a ‘click’. Then run the flexible hose over the hose storage. Insert the other en...

CHECK HOSE INDICATOR & CHECK BAG INDICATOR BRUSHROLL STATUS INDICATOR LIGHT 3. Press the switch to the “II” position for cleaning carpets or rugs. NOTE: The brushroll rotates when the vacuum cleaner is in the “II” position. 4. Once you have completed vacuuming, switch to the “O” position and unp...

3-IN-1 COMBINATION TOOL The 3-in-1 combination tool can be attached to the handle. Slide the collar of the tool over the open end of the handle. Use the 3-in-1 combination tool in crevice tool mode for cleaning in tight spaces such as furniture, between cushions, and stairs. See ATTACHMENT USE TABLE...

*Always clean attachments before using on fabrics. BY-PASS VALVE This vacuum cleaner has a By-Pass Valve which prevents motor overheating and damage. The valve opens to provide cooling air when a clog prevents normal air flow to the vacuum cleaner suction motor. You will notice a change of sound as ...

BRUSHROLL RESET The brushroll has built-in protection against motor damage should the brushroll jam. If the brushroll slows down or stops, the brushroll overload protector shuts off the brushroll motor and the brushroll status indicator light emits red light. The vacuum cleaner suction motor will co...

4. Place the tab on the dust bag chamber cover in the slot on the vacuum cleaner. Push the dust bag chamber cover into place until a ‘click’ is heard. NOTE: Make sure the dust bag is locked into place before pushing the dust bag chamber cover. The dust bag chamber cover can’t be assembled successful...

NOTE: Make sure the exhaust filter cover is properly installed. 2. Remove the HEPA media exhaust filter from vacuum cleaner. 3. Wash with cold water only, DO NOT use detergent or soap. Allow to air dry. Allow parts to dry 24 hours before putting back into vacuum cleaner. NOTE: DO NOT operate without...

PROBLEM POSSIBLE CAUSE SOLUTION Vacuum cleaner won’t run. Unplugged at wall outlet. Plug in firmly, press the On/Off switch to “I” or “II” position. The On/Off switch is not pressed to start the vacuum cleaner. Press the On/Off switch to “I” or “II” position. Defective wall outlet. Check with a good...