Karcher K 2.7 - Manual

English 5 This product is supplied with a Ground Fault Circuit Interrupter (GFCI) built into the power cord plug. This device pro-vides additional protection from the risk of electric shock. If power is interrupted in the line, the GFCI will automatically re-close the circuit to the load after pow-e...

6 English " STEP 1, 2: " STEP 3, 4: " STEP 5, 6: " STEP 7, 8: " STEP 9: " STEP 10: Attach the high pressure hose to the trigger gun. Pull out the locking slide from the right side of the trigger gun handle (A), and insert the small end of the high pressure hose into place (B)...

English 7 " STEP 1: Connect the high pressure hose to the unit’s high pressure outlet. " STEP 2: Insert the spray wand of your choice to the trigger gun. Press in against the spring tension and twist into locked position. " STEP 3: Connect garden hose to unit’s water inlet. " STEP 4:...

8 English " STEP 1: Plug the Ground Fault Cir- cuit Interrupter (GFCI) into a working outlet. " STEP 2: Press ’’TEST’’, then press ’’RESET’’ to assure proper connec-tion to power. Note: The actual appearance of the GFCI may be different from this illus-tration.  WARNING To avoid serious inj...

English 9 Detergents can only be applied at low pressure (Min.). " STEP 1: Install the vario power spray wand. Set the spray wand to the low pres-sure setting (Min.). " STEP 2: Fill a container with Kärcher deter-gent. Place the filter end of detergent suction tube into the container. " ...

10 English " STEP 1: Turn the switch to OFF (0) position and unplug cord from outlet. " STEP 2: Turn off the water source. " STEP 3: Press trigger to release water pres-sure. " STEP 4: Disconnect the garden hose from the water inlet on the unit. " STEP 5: Disconnect the high pres...

English 11 " 1: Disconnect all water connections. " 2: Turn on the machine for a few seconds, until the water which had remained in the pump exits, turn off immediately. " 3: Do not allow high pressure hose to become kinked. " 4: Store the machine and accesso- ries in a room which do...

12 English (with or without detergent). Pre-rinse cleaning surface with fresh water. If us-ing Kärcher Pressure Wash, apply to surface at low pressure (for best results, limit your work area to sections of ap-proximately 6 feet and always apply de-tergent from bottom to top). Allow Pressure Wash to ...

English 13 sults, clean from top to bottom and from left to right. ! Before cleaning any surface an in-conspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. ! If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove ...

14 English Made with soft bristles that will not harm painted surfaces. Easily attaches direct-ly to the trigger gun. Ideal for stubborn dirt on cars, boats, patio furniture and other surfaces. Great for applying deter-gent. Fits most Karcher pressure was-hers up to 2300 PSI. (bayonet) Part No. 2.64...

English 15  CAUTION Disconnect the machine from the power source before making any repair. TROUBLESHOOTING Symptom Cause Solution Motor will not start On/Off switch is in the “OFF” (O) position. Turn switch to the “ON” (I) position Power cord is not plugged in. Plug in power cord.Electrical outlet ...

16 English Call: 1-800-537-4129 for help or visit our website: www.karcher-usa.com If you encounter any additional difficul-ties not listed, please call for help. No detergent. Detergent suction tube not properly connected to the machine. Check connection. Detergent is too thick. Dilute detergent, f...