Jet 414610 - User Manual - manualsarea.com

Page 2 - Warranty and Service

2 1.0 Warranty and Service JET ® warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time per...

Page 3 - Table of Contents

3 2.0 Table of Contents Section Page 1.0 Warranty and Service ..................................................................................................................................... 2 2.0 Table of Contents .................................................................................

Page 4 - Safety Warnings

4 3.0 Safety Warnings 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they b...

Page 5 - About this manual

5 26. Maintain tools with care. Keep cutting tools sharp and clean for the best and safest performance. Follow instructions for lubricating and changing accessories. 27. Turn off machine and disconnect from power before cleaning. Use a brush or compressed air to remove chips or debris — do not use y...

Page 6 - Features

6 5.0 Features Figure 1 1. Spark trap 2. Eye shield 3. Front work support 4. Contact wheel 5. Top work support 6. Belt guard 7. Tracking adjustment knob 8. Belt tension release lever 9. Industrial switch with overload protection 10. Angle lock handle (x2) 11. Drive wheel 12. Dust port 13. Side panel...

Page 7 - Specifications

7 6.0 Specifications Model Number ....................................................................... BG-379-1 .................................................... BG-379-3 Stock Number ............................................................................414610 ..............................

Page 8 - Set-Up and Assembly; Floor Diagram; Unpacking and cleanup; Grounding Instructions; Voltage Conversion; Extension Cords

8 7.0 Set-Up and Assembly 7.1 Floor Diagram Figure 2 7.2 Unpacking and cleanup Inspect contents of shipping container for shipping damage. Report any damage to your distributor. Remove all contents from carton, and compare to the contents list in this manual. Report any part shortages to your distri...

Page 9 - Adjustments; Belt tracking; Belt change; Operation; Contact grinding; Maintenance

9 undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Use Table 1 as a general guide in choosing the correct size cord. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord. Recommended Gauges (AWG) of Extension Cords A...

Page 10 - Troubleshooting; Replacement Parts

10 11.0 Troubleshooting Trouble Probable Cause Remedy Grinder will not start. No incoming power. Check all connections. Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker. Cord damaged. Replace cord. Starting capacitor malfunction (single phase model). Replace starting ca...

Page 11 - BG-379 Belt Grinders – Exploded View

Page 13 - BG-379 Belt Grinders – Parts List

13 12.1.3 BG-379 Belt Grinders – Parts List Index No. Part No. Description Size Qty 1 ................ S-75B-000G .............. Stand ....................................................................... ...................................... 1 2 ................ TS-2342121 .............. Nylon L...

Page 16 - Electrical Connections – BG-379; Single phase only

16 13.0 Electrical Connections – BG-379 13.1 Single phase only 13.2 3-phase only