Invacare 1121271 - Manual
Invacare 1121271 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – front rigging support and the footplate assembly.
- Page 5 – SPRING BUTTON HEIGHT ADJUSTMENT (FIGURE 2); FRONT RIGGINGS in the owner’s manual shipped with wheelchair.
- Page 6 – NOTES
- Page 8 – MADE IN MEXICO
Part No. 1114831
1
Bolt-In-Place/Spring Button
Front Rigging Kit
Bolt-In-Place/Spring Button Front Rigging Kit
Assembly and Installation Instructions
Kits No. 1110266 and 1121271
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Carrier/Dealer for further instruction.
SAFETY SUMMARY
To ensure the safe installation of the Bolt-In-Place/Spring Button Front Rigging
Kit, these instructions MUST be followed:
WARNING
DO NOT install or use this equipment without first reading and understanding
these instructions and the Owner’s Manual supplied with the wheelchair. If you
are unable to understand the Warnings, Cautions or Instructions, contact a
healthcare professional, dealer or technical personnel before attempting to
install this equipment - otherwise, injury or damage may occur.
INSTALLATION WARNING
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Bolt-In-Place Front Rigging Kit 1110266 contains the following items:
DESCRIPTION
QUANTITY
Riv Nut
2
Button Head Screw
2
1/8-inch Hex key
1
Spring Buton Front Rigging kit 1112127 contains the following items:
DESCRIPTION
QUANTITY
Spring buttons
4
INSTALLING THE BOLT-IN-PLACE FOOTPLATE KIT
(FIGURE 1)
NOTE: This kit mounts the footplate assembly to the front rigging support so that tools are required
to remove or adjust the footrest assembly.
1. Remove the front rigging from the wheelchair. Refer to the wheelchair owner’s
manual shipped with wheelchair.
2. Pull up on the cam lock lever to unlock the cam.
NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each
set will be visible one at a time allowing finer footplate height adjustment.
3. Push IN and hold the release button as shown in DETAIL “A” of FIGURE 1.
4. Rotate the lower footplate assembly 1/4 turn.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Bolt-In-Place/Spring Button 2 Part No. 1114831 Front Rigging Kit 5. Remove the lower footplate assembly from the front rigging support.6. Squeeze and push the release button down to remove from the footplate tube.7. Ensure the cam lock lever is UP and unlocked.8. Insert the footplate tube into the f...
Part No. 1114831 5 Bolt-In-Place/Spring Button Front Rigging Kit NOTE: Swingawayfootrests shown. Footplate Assembly Front Rigging Support Cam Lock Lever Riv Nut Button Head Screw NOTE: Swingawayfootrest shown. Front Rigging Support Footplate Assembly Cam Lock Lever Release Button Adjustment Holes Re...
Bolt-In-Place/Spring Button 6 Part No. 1114831 Front Rigging Kit NOTES NOTES NOTES NOTES NOTES
