Invacare 6417 - Manual
Invacare 6417 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FIGURE 1; Assembling the Overbed Table - Model 6417; Assembling the Overbed Table - Model 6418; For; FIGURE 2; Assembling the Overbed Table -
- Page 3 – Operating the Overbed Table; Adjusting Table Height; FIGURE 3
- Page 4 – LIMITED WARRANTY
1
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Deluxe Overbed Table
Model Nos. 6417, 6418
NOTE:
Check
ALL
parts
for
shipping
damage.
If
shipping
damage
is
noted,
DO
NOT
use.
Contact
Carrier/Dealer
for
further
instruction.
Safety Summary
To
ensure
the
safe
and
proper
installation
of
the
deluxe
overbed
table,
these
instructions
MUST
be
followed:
WARNING
DO NOT use this product or any available optional equipment without first
completely reading and understanding these instructions and any additional
instructional material such as owner’s manuals, service manuals or instruction
sheets supplied with this product or optional equipment. If you are unable to
understand the warnings, cautions or instructions, contact a healthcare
professional, dealer or technical personnel before attempting to use this equipment
- otherwise, injury or damage may occur.
ALWAYS check the overbed table for proper tightness before using.
The Deluxe Overbed Table has a weight limitation of 25 lbs.
ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
INSTALLATION WARNING
After any adjustments, repair or service and before use, make sure that all attaching
component parts are secure.
Assembling the Overbed Table - Model 6417
NOTE:
For
this
procedure,
refer
to
1. Invert
the
top
board
and
place
on
floor.
2. Install
the
mast
onto
the
top
board
with
six
mounting
screws.
Tighten
securely.
3. Attach
the
base
above
the
mast
with
the
two
bolts,
washers,
and
inserts.
4. Install
the
four
casters
into
the
four
holes
provided
in
the
base.
5. Flip
the
overbed
table
back
to
the
upright
position.
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Deluxe Overbed Table 2 Part No 1143201 FIGURE 1 Assembling the Overbed Table - Model 6417 Assembling the Overbed Table - Model 6418 NOTE: For this procedure, refer to FIGURE 2. 1. Invert the tilt ‐ top board and place on the floor. 2. Attach the mast to the supp...
Part No 1143201 3 Deluxe Overbed Table Operating the Overbed Table NOTE: For this procedure, refer to FIGURE 3. Adjusting Table Height 1. Remove the transport screw. 2. Squeeze the height adjustable plate upward. 3. Push or pull the table top to the desi...
LIMITED WARRANTY PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.This warranty is extended only to the original purchaser/user of our products.This warranty gives you specific legal rights and you may also have other ...
