INSTEON 2478D - Manual
INSTEON 2478D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Installation; CAUTIONS AND WARNINGS; Tools Needed; Slotted screwdriver
- Page 5 – Installing SwitchLinc – with 1 Switch; SwitchLinc Wire; Table A
- Page 7 – Synchronized
- Page 8 – 8) Connect bare Ground wire from
- Page 9 – Using SwitchLinc; LEDs
- Page 10 – INSTEON Programming; Add SwitchLinc to a Scene as a Responder
- Page 11 – Add SwitchLinc to a Scene as a Controller; Add Multiple Scene Responders); Remove SwitchLinc from a Scene as a Controller; Remove Multiple Scene Responders; LED Brightness
- Page 12 – X10 Programming; Advanced Features; Add Multiple Scene Responders; Synchronize Scenes with 2 SwitchLincs and identify them as A and B
- Page 13 – Switch A’s LED will blink; Air Gap; Pull Set button out (creating an Air Gap)
- Page 14 – Change Paddle and LED Colors; Accessories page on; Local Ramp Rate; Setting the Ramp Rate; Connected light(s) will ramp up and down at the new rate
- Page 15 – Additional Resources; Optional Accessories; Paddle Color Change Kit; Beeper Behavior; Single Beep: Transition from one setup mode to another; Blink LED on INSTEON Traffic; SwitchLinc bottom LED will turn on solid and then turn off
- Page 16 – Specifications
- Page 17 – Troubleshooting; Problem
- Page 18 – ee
- Page 19 – Certification and Warranty
Page 1 of 19 2478D - Rev: 1/21/2014 7:32 AM
SwitchLinc™ Dimmer
INSTEON
®
Remote Control Dimmer
100 - 277VAC, 50/60Hz
Owners Manual (Dual-Band)
(#
2478D
)
Shown above with optional custom etching and screwless wallplates (sold separately)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 4 of 19 2478D - Rev: 1/21/2014 7:32 AM • Quick-Start Guide Installation CAUTIONS AND WARNINGS Read and understand these instructions before installing and retain them for future reference. This product is intended for installation in accordance with the National Electric Code and local regulati...
Page 5 of 19 2478D - Rev: 1/21/2014 7:32 AM Installing SwitchLinc – with 1 Switch 1) Turn off circuit breaker(s) or remove fuse(s) feeding wall box 2) Use a voltage meter to verify that power is off 3) Remove wallplate from the switch and unscrew switch you are replacing and gently pull out 4) Disco...
Page 7 of 19 2478D - Rev: 1/21/2014 7:32 AM SwitchLinc’s LED bar and connected light will turn on Only SwitchLinc in box 2 will operate the Load until you synchronize Scenes to both SwitchLincs in next step 20) Add both SwitchLincs to a Scene as a Controller and Responder of each other (see Synchron...
