INSTEON 2491T1E - Manual
INSTEON 2491T1E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Installation; Setting Up INSTEON Scenes; Adding Venstar Thermostat as an INSTEON Responder; ) Press and hold the scene controller button until it beeps.; Adding Venstar Thermostat as an INSTEON Controller; ) Activate the desired controller mode.
- Page 4 – Remotely Controlling Venstar Thermostat; Adjust Temperature Up or Down by a Degree; Removing Venstar Thermostat as an INSTEON Responder; Controller’s LED will begin blinking.
- Page 5 – Removing Venstar Thermostat as an INSTEON Controller; green; Other Features; Report Readings to Automation Controllers
- Page 6 – To enable change reports; To disable change reports; The thermostat LED will begin blinking; Restoring Power to Thermostat; INSTEON responder (control thermostat
- Page 7 – Factory Reset; The INSTEON LED will turn on after about 20 seconds.; Troubleshooting
Page 1 of 8
Venstar INSTEON
®
Thermostat
Owner’s Manual
INSTEON
®
Remote Control Venstar Thermostat
Model #s -
2491T1E, 2491T7E
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 3 of 8 Installation IMPORTANT: If you are not knowledgeable about and comfortable with electrical circuitry or HVAC installation, you should have a qualified electrician install a compatible thermostat for you. Install the thermostat by following the enclosed Venstar documentation. Note: This t...
Page 4 of 8 i. Tap thermostat mode button until only heat setpoint is displayed. c. Fan: Turns responders on when the fan is turned on via INSTEON or when the thermostat turns fan on via timer or when the user sets fan to always on mode (and off when the reverse happens). i. Open thermostat door and...
Page 5 of 8 2) Press and hold the scene button until controller beeps again. 1 Controller’s LED will continue blinking. 3) Press and hold Set button on thermostat until it double-beeps (about 3 seconds). Thermostat’s LCD will flash all its characters twice. Thermostat’s LED will flash once and retur...
