INSTEON 2477DHxxx - Manual
INSTEON 2477DHxxx – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – The Basics; Installation; Installation – Circuit with 1 Switch; In the Box
- Page 4 – SwitchLinc and its connected load will turn on; Installation – Circuit with 2 Switches
- Page 5 – Both SwitchLincs and the connected load will remain in synch; Installation – Circuit with 3 (or more) Switches
- Page 6 – Local Control; Tap for ON, press and hold to brighten
- Page 7 – INSTEON Setup; INSTEON Controllers, Responders and Links; Controller LED will start blinking
- Page 8 – Make SwitchLinc a Controller
- Page 9 – Remove SwitchLinc as a Controller (Unlink); Accessories page on; Using Air Gap
- Page 10 – SwitchLinc ships with no X10 address assigned.; Add X10 Address; Local Settings; To set local on-level to a fixed brightness level
- Page 11 – Local Ramp Rate
- Page 12 – Error Blink; Specifications
- Page 13 – Troubleshooting; Problem
- Page 15 – Certification and Warranty
Page 1 of 15 Rev: 1/21/2014 7:29 AM
SwitchLinc™ Dimmer High Wattage
INSTEON
®
Dual-Band Remote Control Dimmer
Owner’s Manual (rev 7.0+)
(#
2477DHxxx
)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 3 of 15 Rev: 1/21/2014 7:29 AM The Basics Cautions and Warnings Read and understand these instructions before installing and retain them for future reference. This product is intended for installation in accordance with the National Electric Code and local regulations in the United States or th...
Page 4 of 15 Rev: 1/21/2014 7:29 AM 7) Turn off power 8) Connect wires as per table/diagram (confirm firm attachments with no exposed wire) If you are installing SwitchLinc in a multi-gang box next to another switch, you may need to remove one or both pairs of metal heatsink tabs on the back of Swit...
Page 5 of 15 Rev: 1/21/2014 7:29 AM 13) Connect SwitchLinc white wire to neutral wire(s) in wall box (usually white) 14) Connect SwitchLinc red wire to load wire 15) Connect SwitchLinc black wire to same color traveler from Box 1 carrying Line (usually black) 16) Cap unused traveler wire 17) With LE...
