INSTEON 2442-222 (US) - Manual
INSTEON 2442-222 (US) – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – About Micro Dimmer; Features and Benefits; In the Box; Before Installation
- Page 5 – Identify Switch Type
- Page 6 – Installation
- Page 7 – Switch Operation Mode; Change to Single Momentary Mode
- Page 9 – Local Control Operation; Single Momentary Switch
- Page 10 – Adjust Local Settings; Local Ramp Rate
- Page 11 – Ramp Rate Presets; Resume Dim
- Page 12 – INSTEON Setup; INSTEON Controllers, Responders and Links; controller
- Page 16 – Factory Reset; Add X10 Address
- Page 17 – Specifications
- Page 20 – Troubleshooting; Problem
- Page 23 – Certification and Warranty
Page 1 of 24
2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM
Micro Dimmer
Owner’s Manual
2442-222 (US)
2442-422 (EU)
2442-522 (AUS/NZ)
North America
EU/AUS/NZ
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 4 of 24 2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM About Micro Dimmer Features and Benefits - Integrated dimmer featuring 32 dim levels and 32 ramp rates - Wires in behind existing wall switch or in fixture box (requires neutral wire) - Compatible with latching, single momentary and du...
Page 5 of 24 2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM specifications. If this device supports dimming, please note that dimming an inductive load, such as a fan or transformer, could cause damage to the dimmer, the load bearing device, or both. If the manufacturer of the load device does ...
Page 6 of 24 2442-222/2442-422/2442-522 - Rev: 1/21/2014 8:00 AM Installation 1) Write down the INSTEON ID found on the back of the unit (XX.XX.XX) 2) Turn off breaker/fuse and verify that the power is off 3) Disconnect wires from existing switch, fixture or outlet and prep all wires to be connected...
