Hunter 43255 - Manual

Hunter 43255 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – Low Battery Indicator:; IMPORTANT INFORMATION; This thermostat is designed to work on the following systems:; FEATURES; What You Need; Remove Old Thermostat; Typical Home Thermostats; RH; Figure 1; Wire Labeling
Page 3 – Table A; Mount Wallplate and Thermostat; Connect Wires and Mount Thermostat to Wallplate; Switch on the main power at the panel or furnace.; Figure 4; Rh; Figure 2
Page 4 – Wiring Diagrams; Supply; Selector Switches; Program. If you prefer to use normal recovery, slide the; Press and hold the Up key.; OPERATION; Setting Day and Time; AM
Page 5 – Press again to change back to the; NOTE: You may press; PROGRAMMING; All 7 days of the week have the same default programs.; Personal Program Schedule; Heating; PM
Page 6 – To end the Temporary Manual Override:; You can confirm the held set temperature by; To end the Permanent Manual Override:; or; The Span settings remain the same for both HEAT and COOL.
Page 7 – HEAT TEMP; Climate Technology’s Auto Recovery feature meets the ENERGY STAR

Loading the manual

Model 43255

Owners Manual

PROGRAMMABLE
THERMOSTAT

TEMP

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Low Battery Indicator:; IMPORTANT INFORMATION; This thermostat is designed to work on the following systems:; FEATURES; What You Need; Remove Old Thermostat; Typical Home Thermostats; RH; Figure 1; Wire Labeling

2 (Continued) day/time reset system heat cool off program filter hold /return fan auto on M AM 4 TEMP Hold / Return Key: Used for setting a permanent (vacation)hold, and for returning to thenormal display from Day & Timesetting, Programming, or Spansetting modes. LCD Display: Shows Time, Day, Te...

Page 3 - Table A; Mount Wallplate and Thermostat; Connect Wires and Mount Thermostat to Wallplate; Switch on the main power at the panel or furnace.; Figure 4; Rh; Figure 2

3 Wire Labeling (Continued) ■ After labeling wires, disconnect them from the existing thermostat terminals. ■ Remove existing wallplate. To make sure wires do not fall back into wall opening, you maywant to tape them to the wall. ■ If hole in wall is larger than necessary for wires, seal this hole w...

Page 4 - Wiring Diagrams; Supply; Selector Switches; Program. If you prefer to use normal recovery, slide the; Press and hold the Up key.; OPERATION; Setting Day and Time; AM

4 (Continued) Wiring Diagrams X - No Connection 4-wire Heat/Cool System Jumper WallplateTerminals FanRelay CoolContactor Heat Relayor Valve 24V Supply Heat/Cool Rh Rc Y/O W/B Y1 G X X System Selector STD HP – No Jumper WallplateTerminals FanRelay Cool 24V Supply Heat Relayor Valve Heat 24V Supply Rh...