Honeywell 8675I - Manual

4 Install the Battery The device ships with a 3.85V, 570 mAh battery manufactured by Honeywell International Inc. Use only Honeywell battery model BAT-SCN10.

5 Replace the Battery Note: The battery should be replaced in an environment free from excessive dust or particulate to avoid an internal buildup of dust in the unit. When the battery is low, the 8675i beeps, vibrates, and the Battery LED flashes. To replace the battery, squeeze the battery latches ...

6 Right or Left Handed Operation To release the finger trigger, turn over the device. Press the Release Latch on the bottom. Rotate the trigger and snap it into place to change the operation to the correct hand.

8 Wrist Position When Scanning How to Scan a Barcode The 8675i scanner has a view finder that projects a bright laser aiming pattern. This aiming pattern should be centered over the barcode, but it can be positioned in any direction for a good read. ! Warning: Do not stare directly into the laser be...

9 Connect the Device via Bluetooth® Pair with a PC or Laptop Bluetooth Serial Port: Host Reconnect Mode The 8675i can pair with host Bluetooth devices such as personal computers, laptops, and tablets. In this mode, the host will continually attempt to connect with the device. If the device and the h...

10 Pair with a PC or Laptop Bluetooth: HID Keyboard Mode In this mode, the 8675i pairs with a Bluetooth device using a HID keyboard. 1. Scan the Bluetooth HID Keyboard Connect barcode below. 2. Set your host device so it searches for other Bluetooth devices. (Refer to your host device’s User’s Guide...

11 Disconnect from the Host Once your device has been connected to a host, you must disconnect it in order to communicate with a different device. Scan the Bluetooth Disconnect barcode to unlink the device from the currently linked host. Pair with an Android™ Mobile Device Tap and Pair You can pair ...

13 Pair with a Honeywell Vehicle Mount Computer The 8675i can pair with Honeywell vehicle mount computers, such as the Thor VM1 or VM2, or with Tecton mobile computers. 1. Scan the Bluetooth HID Keyboard Disconnect barcode below. 2. Use the 8675i to scan the EZPairing barcode that is either supplied...

14 Pair with a Vocollect Device In this mode, the scanner will continually attempt to connect with the host. If the scanner and the host become disconnected, the scanner will manage the reconnection. 1. Scan the Bluetooth Serial Port Profile Connect barcode below. 2. Configure the 8675i with the ter...

15 each Vocollect device. The EZPairing barcode begins with {FNC3} LnkB, followed by 12 digits, like the sample below. 5. The Bluetooth LED flashes continuously when the 8675i pairs with a host. Once the 8675i battery is charged and you have paired it to a host device, you may begin scanning barcode...

16 Support Go to sps.honeywell.com and select Support to search our knowledge base for a solution or to log into the Technical Support portal. User Documentation For the user guide and other documentation, go to sps.honeywell.com . Limited Warranty For warranty information, go to sps.honeywell.com a...