Honeywell 2000B - Manual
Honeywell 2000B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FlashGuard 2000B Troubleshooting Guide
- Page 3 – Multiple Strobe Problems
- Page 4 – Section 1; Flashhead does not operate in any mode, no LED’s on.; Section 2
- Page 6 – Section 6; System will not switch between day and night modes correctly.
- Page 7 – Section 7; Mis-configured or defective sync monitor board.; Possible Cause; Section 8; Replace the K2 relay.; MULTIPLE STROBE PROBLEMS; Section 9; Flashheads are operating, but out of sync.; Possible Cause; Configure sync board as referenced in manual.
- Page 8 – More than one sync monitor board is set as master.; Master unit switches to night mode at night, but slave units remain; Install interconnecting wiring.
- Page 9 – Flashhead Isolation Test; Flashhead Test Results
- Page 10 – Power Supply Isolation Test; Voltage Measurements
- Page 12 – Recommended Spare Parts
FlashGuard 2000B Medium Intensity Lighting System
Troubleshooting Guide
Table of Contents
Flashhead (Strobe) Troubleshooting Flowchart
pg. 2
Multiple Strobe Troubleshooting Flowchart
pg. 3
Flashhead Problems
pg. 4
Multiple Strobe Problems
pg. 7
Flashhead Isolation Test
pg. 9
Power Supply Isolation Test
pg. 10
Status Indicators
pg. 11
Tools Required
pg. 11
Recommended Spare Parts
pg. 12
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
FlashGuard 2000B Troubleshooting Guide Page 2 Flashhead (Strobe) Problems START Flashhead works in at least one mode? No Are all of the LEDs OFF? Control Power ON, High Voltage OFF? No Control Power and High Voltage Both ON ? No Yes Day mode strobe is OK, Night strobe out? Section 1, pg. 4 Yes Yes Y...
FlashGuard 2000B Troubleshooting Guide Page 3 Multiple Strobe Problems . No Strobes are flashing out of sync. Yes Section 9, pg. 8 No Strobes have a ‘double flash’ or are flashing faster than 40 FPM? Yes Section 10, pg. 8 Master switches to night, but slaves stay in day mode? Yes Section 11, pg. 8 S...
FlashGuard 2000B Troubleshooting Guide Page 4 FLASHHEAD (STROBE) PROBLEMS Section 1 Flashhead does not operate in any mode, no LED’s on. Possible Cause : Input power incorrect. Diagnostic Test : Measure input power – it should be 120 VAC ±10%. Corrective Action: Supply correct input power. Possible ...
