Henny Penny OFE/OFG-323 - Manual
Henny Penny OFE/OFG-323 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 5 – Electric; breaker, or unplug cord at wall receptacle.; Gas
- Page 6 – REPLACEMENT; ELECTRIC
- Page 7 – Tighten the compression nut hand tight and then a half turn; Excess force will damage temperature probe.
- Page 20 – Heating elements should never be energized without
- Page 29 – securing the autolift PC board bracket to the frame and remove
Model OFE/OFG-321,322,323,324
SECTION 2. MAINTENANCE
2-1. INTRODUCTION
This section provides procedures for the checkout and replacement
of the various parts used within the fryer. Before replacing any
parts, refer to the Troubleshooting Section. It will aid you in
determining the cause of the malfunction.
2-2. MAINTENANCE HINTS
1. You may need to use a multimeter to check the electric
components.
2. When the manual refers to the circuit being closed, the
multimeter should read zero unless otherwise noted.
3. When the manual refers to the circuit being open, the
multimeter will read infinity.
2-3 HIGH TEMPERATURE
LIMIT CONTROL
The high temperature limit control is a safety, manual reset control
(Gas Units)
that senses the temperature of the shortening. If the shortening
temperature
exceeds
425
°
F (218
°
C), this switch will open
and shut off heat to the frypot. When the temperature of the
shortening drops to a safe operation limit, the control must be
manually reset by pressing the red reset button. The red reset
button is located under the control panel, in the front of the fryer.
This will allow heat to be supplied to the frypot once again.
Checkout
Before replacing a high temperature limit control, check to see
that
its
circuit
is
closed.
The shortening temperature must be below 380
°
F
(193
°
C) to accurately perform this check.
Checkout:
1.
Remove electrical power supplied to fryer.
To avoid electrical shock or property damage, move the
POWER switch to OFF and disconnect main circuit
breaker,
or
unplug
cord
at
wall
receptacle.
2.
Remove the control panel.
203
2-1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Model OFE/OFG-321,322,323,324 2-5. POWER SWITCH (Continued) 4. With control panel removed, and the wires off the switch, push in on tabs on the switch to remove from panel. 5. Replace with new switch, and reconnect wires to switch. 6. Replace the control panel. 2-6. TEMPERATURE PROBE The temperature...
Model OFE/OFG-321,322,323,324 2-6. TEMPERATURE PROBE REPLACEMENT (Continued) ELECTRIC GAS 2-6 606
Model OFE/OFG-321,322,323,324 2-6. TEMPERATURE PROBE 7. Tighten the compression nut hand tight and then a half turn REPLACEMENT with wrench. (Continued) Excess force will damage temperature probe. 8. Connect new temperature probe to PC board and replace control panel. 9. Replace shortening. 10. Turn...
