Henny Penny HB-121 - Manual
Henny Penny HB-121 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
HB-121
SECTION 2. INSTALLATION AND OPERATION
2-1. INTRODUCTION
This section provides the installation and operation instructions for
the Henny Penny Hand Breader/Sifter.
Installation of this unit should be performed by a qualified
service technician.
Do not puncture the skin of the Hand Breader/Sifter with
drills or screws as component damage or electrical shock
could result.
2-2. UNPACKING AND
The Henny Penny Hand Breader/Sifter is shipped in a corrugated
ASSEMBLY
carton with sufficient padding to withstand normal shipping
treatment.
Any shipping damages should be noted in the presence of the
delivery agent and signed prior to his or her department.
To remove the HB-121 from the carton follow these instructions:
1. Carefully cut banding straps.
2. Remove carton from unit.
3. Remove unit from wooden skid.
Take care when lifting unit to prevent personal injury.
The unit weighs approximately 140 lbs. (63.5 kg).
4. Remove all accessories from unit for assembly.
The hand breader/sifter unit is completely assembled and tested
at the factory. However, to make shipping easier, some parts
are separated from the unit. These parts should be assembled
and installed at this time as follows. Refer to exploded view in
rear of this manual.
5. Assemble gussets (brackets) to back splash using four 10-24
wing nuts found in plastic bag taped to the breading table.
203
2-1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
