Henny Penny CMC/CMR-106 - Manual
Henny Penny CMC/CMR-106 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Henny Penny
- Page 3 – Turn power switch to ON position.
- Page 4 – Clean interior surfaces with a soft cloth, soap and water.
- Page 5 – Temperature Setpoint
- Page 6 – Continued
- Page 7 – UL Units; Remove the bulb guard caps.; CE Units; Remove the bulb cover.
Henny Penny
Model CMC/CMR-103,104,105,106,107
3-1. INTRODUCTION
This section provides explanations of all controls, along
with operating procedures and daily maintenance. Read the
Introduction, Installation and Opeation Sections before
operating the unit.
Wait at least 4 hours before plugging the unit into an
electrical supply. The gases and oils in the refrigeration
system needs to settle before operating the compressor, or
damage to the compressor could result.
3-2. OPERATING CONTROLS
Refer to figure 3-1.
Fig.
Item
Description
Function
No.
No.
3-1
1
Power Switch
Turns electrical power off and on to the unit; located on the
bottom of the control panel
3-1
2
Digital Display
Shows the temperatures and the information in the Technical
Mode
3-1
3
Used to increase setpoint values, as well as programming
values; also, automatic defrost cycles are programmed in
the controls, but to manually start a defrost cycle, press and
hold for 3 seconds to start a manual defrost cycle;
“DEF/SET’ shows in display
3-1
4
Used to decrease setpoint values, as well as programming
values
3-1
5
Press to view the setpoint temperature, or hold it for it for 4
seconds to enter the program mode; once in the Program
Mode, press to view other parameter setpoints;
Press , along with and to change the
parameters
SECTION 3. OPERATION
3-1
303
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Henny Penny Model CMC/CMR-103,104,105,106,107 Figure 3-1 3 2 1 4 5 303 3-2 3-2. OPERATING CONTROLS (Continued)
Henny Penny Model CMC/CMR-103,104,105,106,107 3-3. BASIC OPERATION 1. Turn power switch to ON position. 2. Wait for temperature to reach operating temperature,34 to 38° F (1.1 to 3.3° C). 3. Place chilled product into case. Do not block the air return and air discharge vents withproduct. Product tem...
Henny Penny Model CMC/CMR-103,104,105,106,107 3-4. CLEANING Every 3 Months: (Continued) 1. Remove all electrical power supplied to the unit by unpluggingthe power cord from the wall, or by turning off the wall circuitbreaker. 2. Remove all product from the unit. 3. Remove the riser and trays from th...
