Henny Penny 691 - Manual
Henny Penny 691 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Model 691
Power switch ON but fryer
completely inoperative
Pressure not exhausting at
end of cook cycle
Operating pressure too high
4-1. TROUBLESHOOTING GUIDE
Problem
Cause
Correction
• Open circuit
• Solenoid or exhaust line clogged
• Deadweight assembly clogged
•
Plug fryer in
• Check breaker or fuse at wall
• Turn OFF and allow fryer to cool to
release the pressure in frypot; have
all lines, solenoid, and exhaust tank
cleaned
• Turn OFF and allow fryer to cool to
release the pressure in frypot; clean
deadweight per Section 3-15
DO NOT OPERATE UNIT IF PRESSURE GAUGE SHOWS HIGH-PRESSURE CONDITIONS.
SEVERE INJURIES AND BURNS WILL RESULT. PLACE THE POWER/PUMP SWITCH IN
THE OFF POSITION IMMEDIATELY. RELEASE THE PRESSURE BY ALLOWING UNIT
TO COOL. THE PRESSURE THEN DROPS. DO NOT RESUME USE OF UNIT UNTIL CAUSE
OF HIGH PRESSURE HAS BEEN FOUND AND CORRECTED.
Pressure does not build
Shortening not heating
Foaming or boiling over
Shortening not draining
Filter motor won’t run
• Not enough product in frypot
• Metal shipping spacer not
removed from deadweight
• Pressure not programmed
• Lid gasket leaking
• Gas valve knob turned to the
OFF position
• Drain valve open
• High temperature limit tripped
• See Boil-Over label on fryer
and information in this manual
• Drain valve clogged
• Motor overheated
• Place full capacity product in frypot
when using fresh shortening
• Remove shipping spacer; see
Section 2-2
• Check programming
• Reverse or replace lid gasket
• Make sure gas control valve knob is
turned to the ON position
• Close drain valve
• Reset high temperature limit
• Follow Boil-Over procedures
• Push cleaning rod through open
drain valve
• Reset motor
More detailed troubleshooting information is available in the Technical Manual, available at www.hennypenny.com,
or 1-800-417-8405 or 1-937-456-8405.
803
4-1
SECTION 4. TROUBLESHOOTING
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
