Heatiator ADI60S - Manual

Heatiator ADI60S

Heatiator ADI60S – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
Page: / 41

Table of Contents:

  • Page 2 – Congratulations; Listing Label Information/Location; Owner’s Manual; Read this manual before installing or operating this appliance.; Homeowner Reference Information; N A
  • Page 3 – Table of Contents
  • Page 4 – Note; Listing and Code Approvals; C. High Altitude Installations; Models; A. Appliance Certifi cation; Material which will not ignite and burn. Such materials are; E. Combustible Materials Specifi cation; • A 110-120 VAC circuit for this product must be protected; WARNING; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.
  • Page 5 – Getting Started; C. Inspect Appliance and Components; • Read all of the instructions before starting the insta-; CAUTION; Any such action may cause a fi re hazard.
  • Page 6 – TOP VIEW; Fireplace Size Requirements; A. Minimum Fireplace Opening; • Any smoke shelves, shields and baffl es may be removed
  • Page 8 – A. Vent Termination Minimum Clearances; Termination Locations
  • Page 9 – C. Measuring Standards; • Vertical terminations are measured to top of chimney.; B. Horizontal Venting; Horizontal venting is NOT allowed.; Vent Information and Diagrams; Symbol
  • Page 10 – Installation Preparation; D. Hearth or Hearth Extension
  • Page 11 – A. Venting Components; Installing Vent Pipe and Appliance; B. Connecting Vent Pipe
  • Page 13 – D. Installing Adaptor and Termination Cap; Damper Flashing Kit; : Damper may have to be removed to use this kit.; system REQUIRES this insulation.; Masonry; OR
  • Page 14 – Gas Information; • If substituting for these components, please consult; Reference Section 15; Pressure
  • Page 15 – HIGH ALTITUDE INSTALLATIONS; • A small amount of air will be in the gas supply lines.
  • Page 16 – A. Wiring the Appliance; Electrical Information; • An ON/OFF switch is included with appliance and should; Appliance Requirements; • This appliance DOES NOT require 110-120 VAC to
  • Page 17 – B. Junction Box Installation; Optional Accessories; • Plug the cord into a convenient outlet.
  • Page 19 – A. Mantel Projections; Finishing
  • Page 20 – Appliance Setup; A. Remove Shipping Materials; Placing the Ember Material; • Embers CANNOT be placed directly over ports.
  • Page 21 – E. Refractory Placement; Refractory Placement; Refractory is fragile! Carefully remove the
  • Page 22 – F. Positioning the Logs; Logs are fragile! Carefully remove
  • Page 23 – Push the right side forward against the right grate tine.
  • Page 24 – of the log slopes down and to the left.
  • Page 25 – H. Air Shutter Setting; Model; Removing Glass Assembly; To release glass assembly, pull the two bottom spring-; Replacing Glass Assembly; Tilt glass assembly toward fireplace and slide glass
  • Page 26 – A. Before Lighting Appliance; Operating Instructions; HOT SURFACES
  • Page 27 – B. Lighting Appliance; Standing Pilot Ignition; NOT FOR USE; WHAT TO DO IF YOU SMELL GAS
  • Page 28 – Initial Break-in Procedure
  • Page 29 – E. Frequently Asked Questions; ISSUE
  • Page 30 – A. Standing Pilot Ignition System; Troubleshooting; Symptom
  • Page 32 – When cleaning glass door:
  • Page 34 – Reference Materials; A. Appliance Dimension Diagram
  • Page 35 – B. Vent Kits Components
  • Page 36 – Service Parts Diagram; Part number list on following page.; Log Set Assembly
  • Page 37 – Service Parts; Stocked; ITEM
  • Page 39 – CONDITIONS, EXCLUSIONS & LIMITATION OF LIABILITY
  • Page 41 – E. Contact Information; DO NOT DISCARD THIS MANUAL; For the location of your nearest Heatilator dealer,
Loading the manual

1

Heatilator • ADI60S • 345-900 Rev. G • 9/08

Model:
ADI60S

• Do not store or use gasoline or other fl am-

mable vapors and liquids in the vicinity of
this or any other appliance.

• What to do if you smell gas

- Do not try to light any appliance

- Do not touch any electrical switch. Do not

use any phone in your building.

- Immediately call your gas supplier from a

neighbor’s phone. Follow the gas suppli-
er’s instructions.

- If you cannot reach your gas supplier, call

the fi re department.

• Installation and service must be performed

by a qualifi ed installer, service agency, or the
gas supplier.

WARNING: If the information in these

instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.

Owner’s Manual

Installation and Operation

DO NOT DISCARD THIS MANUAL

CAUTION

This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions and
the manufactured home construction and safety standard,

Title

24 CFR, Part 3280

or

Standard for Installation in Mobile Homes,

CAN/CSA Z240MH.

This appliance is only for use with the type(s) of gas indicated
on the rating plate.

• Leave this manual with

party responsible for use
and operation.

DO NO

T

DISCARD

• Important operating

a n d m a i n t e n a n c e
instructions included.

• Read, understand and follow

these instructions for safe
installation and operation.

In the Commonwealth of Massachusetts:
• installation must be performed by a licensed plumber

or gas fi tter;

• a CO detector shall be installed in the room where the

appliance is installed.

Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.

WARNING

This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.

Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.

HOT SURFACES

!

Glass and other surfaces are hot during
operation AND cool down.

Hot glass will cause burns.

•

DO NOT

touch glass until it is cooled

• NEVER allow children to touch glass
• Keep children away

• CAREFULLY SUPERVISE children in same room as

fi replace.

• Alert children and adults to hazards of high temperatures.

High temperatures may ignite clothing or other fl ammable
materials.

• Keep clothing, furniture, draperies and other fl ammable

materials away.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Congratulations; Listing Label Information/Location; Owner’s Manual; Read this manual before installing or operating this appliance.; Homeowner Reference Information; N A

Heatilator • ADI60S • 345-900 Rev. G • 9/08 2 Congratulations Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ Location on appliance: ____________________ ...

Page 3 - Table of Contents

3 Heatilator • ADI60S • 345-900 Rev. G • 9/08 Table of Contents 1 Listing and Code Approvals A. Appliance Certifi cation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4B. BTU Specifi cations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4C. High Altitude Installations . . ....

Page 4 - Note; Listing and Code Approvals; C. High Altitude Installations; Models; A. Appliance Certifi cation; Material which will not ignite and burn. Such materials are; E. Combustible Materials Specifi cation; • A 110-120 VAC circuit for this product must be protected; WARNING; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.

Heatilator • ADI60S • 345-900 Rev. G • 9/08 4 Note : To assure top performance, safety and effi ciency, inserts must be installed with an approved fl ue liner as per CAN/CGA B-149 or National Fuel Gas Code ANSI Z223 and these instructions. Note: This installation must conform with local codes. In th...

Other Heatiator Models

All Heatiator Other