Heat & Glo TIARAP-CES - Manual
Heat & Glo TIARAP-CES – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Page 2; Read this manual before installing or operating this appliance.; Congratulations; . Pay special attention to all Cautions and; SAMPLE OF RATINGS LABEL; Model Name; L E; Barcode
- Page 3 – Page 3
- Page 4 – Page 4; Listing and Code Approvals; cation; This installation must conform with local codes. In the; National; and the; CAN/CGA B149 Installation Codes; D. High Altitude Installations; WARNING; MODEL; Model; F. Combustible Materials
- Page 5 – Page 5; The following requirements reference various
- Page 6 – Page 6; Getting Started; and national codes and regulations.; CAUTION; B. Tools and Supplies Needed; tools will apply to every installation.; • Installation and use of any damaged appliance or vent; Any such action may cause a; warranty will be; Report damaged parts to dealer.
- Page 7 – Appliance Location and Clearances; A. Selecting Appliance Location
- Page 8 – Page 8; Termination Locations; A. Vent Termination Minimum Clearances; specifi es minimum vent heights for various; Roof Pitch; Measure vertical clearances from this surface.; • Do not pack air space with insulation or
- Page 9 – public; Alcove Applications
- Page 10 – Vent Information; A. Venting Components; • Vent this appliance directly outside.; Figure; C. Measuring Standards; ALL vent confi guration specifi cations MUST be followed.
- Page 11 – How to Use the Vent Graph; Example 1
- Page 12 – F. Horizontal Termination; Type C - 45° Elbow in Corner Installation; Female Locking Lugs; Note; : Female ends of direct vent pipe/elbows are designed
- Page 13 – (1) The four wood screws provided should be replaced with; . Cut and frame the
- Page 14 – Local codes may require installation of a cap; Some termination caps may cause the vent; Impaired Performance of Appliance.; • Ensure vent components are locked together correctly.; The attachment from the vent pipe to the vent
- Page 15 – Check the instructions below for maximum vertical rise; NOTE; : Maximum number of 45° elbows permitted for a; et the gas appliance in its desired location. Drop a plumb; G. Vertical Termination; • Do not pack air space with insulation or other
- Page 16 – ) If an offset is necessary in the attic to avoid obstructions,
- Page 17 – • Any occupied areas above the first floor, including; For multi-story vertical installations, a ceiling firestop
- Page 18 – Trim Collar
- Page 19 – Class A Metal Chimney; Sheet Metal Screws; Remove existing chimney cap.
- Page 22 – ). Mount the retro connector to the masonry wall using; wind termination cap on to the top adapter.
- Page 23 – the next page; Slim Line Wall Thimble; Assembling Slim Line Trim Ring and Heat Shield; Figure A; Sharp Edges
- Page 24 – FIG. A 90 DEGREE ELBOW; FIG. C MINIMUM CLEARANCE; FIG. B 45 DEGREE ELBOW; THROUGH THE WALL
- Page 25 – Gas Information; Converting to LP Gas; Pull off pilot hood and set aside.; Remove 2 screws; Use a 5/32 in. Allen wrench to remove the pilot
- Page 26 – If the information in these instructions is; • Do no install a valve or regulator that has been; Valve Regulator Replacement; Disconnect any electrical cords and
- Page 27 – • If substituting for these components, please consult; We recommend; PRESSURE
- Page 28 – HIGH ALTITUDE INSTALLATIONS
- Page 29 – Electrical Information; A. Recommendation for Wire; DOES NOT; This appliance must be electrically wired and; National Electric Code ANSI/NFPA; or the; Canadian Electric Code, CSA; Wire Size
- Page 30 – To access the module:; • Wire must have high temperature insulation.; Battery polarity must be correct or module damage will occur.
- Page 31 – Appliance Setup; A. Remove Shipping Materials
- Page 32 – D. Intake Damper Operation; CLOSE; E. Intake Air Shutter Adjustment; OPEN
- Page 33 – Place the twig with the center resting on the fl at
- Page 34 – I. Blower Installation; TOOLS REQUIRED; SNAP DISC
- Page 37 – Handle glass assembly with care.; • Replace glass assembly as a complete
- Page 38 – Operating Instructions; A. Before Lighting Appliance; Fumes; VALVE CONTROL; • Keep children away.
- Page 39 – C. Lighting Appliance; WHAT TO DO IF YOU SMELL GAS:; result causing property damage, personal injury or loss of life
- Page 40 – D. After Appliance is Lit; Initial Break-in Procedure; E. Frequently Asked Questions; ISSUE
- Page 41 – Troubleshooting; Symptom
- Page 42 – Check the burner orifi ce for stoppage. Remove stoppage.
- Page 43 – Longer operation without cleaning; When cleaning glass door:
- Page 44 – USE CAUTION WHEN CLEANING/HANDLING CERAMIC BURNER.
- Page 45 – Reference Materials; A. Appliance Dimension Diagram
- Page 46 – B. Vent Components Diagram
- Page 47 – C. Vent Components List
- Page 49 – Service Parts List; TIARA PETITE B; Item
- Page 50 – Valve Bracket
- Page 53 – Accessories; Part Description
- Page 54 – F. Service and Maintenance Log; Date of Service
- Page 55 – unless expressly authorized and approved by HEAT & GLO in writing.
- Page 56 – CONTACT INFORMATION; For the number of your nearest Heat & Glo dealer,; DEALERSHIP WHERE PURCHASED:; Your Records for Model:; Tiara Petite B; H. Contact Information
DO NOT DISCARD THIS MANUAL
CAUTION
• Important operating and
maintenance instructions
included.
• L e a v e t h i s m a n u a l w i t h
party responsible for use
and operation.
• Read, understand and
follow these instructions
for safe installation and
operation.
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
- D o n o t t r y t o l i g h t a n y a p p l i a n c e .
Do not touch any electrical switch. Do not
use any phone in your building.
- Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
- If you cannot reach your gas supplier, call
the fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a
fi
re
or explosion may result causing property
damage, personal injury, or death.
7026-101K
This appliance may be installed as an OEM installation in manufactured
home (USA only) or mobile home and must be installed in accordance with
the manufacturer's instructions and the manufactured home construction and
safety standard, Title 24 CFR, Part 3280 or Standard for Installation in Mobile
Homes, CAN/CSA Z240MH.
This appliance is only for use with the type(s) of gas indicated on the rating plate.
Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory-trained
professionals, or technicians supervised by an NFI
certifi ed professional.
DO NO
T
DISCARD
TIARA PETITE B
DIRECT VENT ROOM HEATER
Owner’s Manual
Installation and Operation
TIARAP-BK
TIARAP-BR
TIARAP-CES
TIARAP-CTO
Model:
O - T
O - T L
Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C
US
In the Commonwealth of Massachusetts:
• installation must be performed by a licensed plumber or gas
fi tter.
See Table of Contents for additional Commonwealth of Mas-
sachusetts requirements.
www.heatnglo.com
August 1, 2008
HOT SURFACES!
Glass and other surfaces are
hot during operation AND
cool down.
WARNING
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in the same room
as appliance
• Alert children and adults to hazards of high
temperatures
High temperatures may ignite clothing or other
fl
ammable materials.
• Keep clothing, furniture, draperies and other
combustibles away.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 Heat & Glo · Tiara Petite B · 7026-101J August 1, 2008 Read this manual before installing or operating this appliance. Please retain this owner's manual for future reference. Congratulations Congratulations on selecting a Heat & Glo gas appliance - an elegant and clean alternative to ...
Page 3 Heat & Glo · Tiara Petite B · 7026-101K - TABLE OF CONTENTS - August 1, 2008 Section 1: Listing and Code Approvals A. Appliance Certifi cations ...................... 4 B. Glass Specifi cations ............................ 4 C. Specifi cations ...................................... 4 D. H...
Page 4 August 1, 2008 Heat & Glo · Tiara Petite B · 7026-101K 1 Listing and Code Approvals The product is listed to ANSI standards for “Vented Gas Appliance Heaters” and applicable sections of “Gas Burning Heating Appliances for Manufactured Homes and Recre-ational Vehicles” and "Gas Fired A...
