Heat & Glo SLR-B (COSMO) - Manual
Heat & Glo SLR-B (COSMO) – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Listing Label Information/Location; We recommend that you record the following pertinent; Homeowner Reference Information; NA; XXXXXXXX; Read this manual before installing or operating this appliance.
- Page 3 – Safety Alert Key:; Used to address practices not related to personal injury.; Table of Contents; User Guide
- Page 5 – glass
- Page 6 – B. Limited Lifetime Warranty; This warranty is void if:
- Page 7 – Models; Standard Test Method for Behavior of Materials in a; shall be; National Electric Code ANSI/NFPA; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.; This appliance is tested and approved as either supplemen-; ori; Listing and Code Approvals
- Page 8 – tter; The following requirements referenc e var ious
- Page 9 – WARNING! DO NOT operate fi; A. Gas Fireplace Safety; WARNING; This appliance has been supplied with an integral barrier; HOT SURFACES; ammable; Operating Instructions; Keep glass rock media
- Page 10 – E. Fixed Glass Assembly; This decorative front has been supplied with an; F. Remote Controls, Wall Controls and Wall; have a; WARNING! Risk of Fire or Asphyxiation! DO NOT
- Page 11 – life, remove them when using the transformer.; LIGHTING; NOT FOR USE; GAS; on the; WHAT TO DO IF YOU SMELL GAS; DO NOT CONNECT LINE VOLT-; Hot; Also Certifi ed for Installation in a; Final inspection by
- Page 12 – Initial Break-in Procedure; • The fireplace should be run three to four hours; I. After Fireplace is Lit; ISSUE; ames
- Page 13 – Glass Cleaning; Tools Needed; CAUTION! Handle fi xed glass assembly with care.; Note; Maintenance and Service; The; Tools needed; Remote Control; Any safety screen or guard removed for servicing must be
- Page 15 – A. Typical Appliance System; Illustrations and photos re; Getting Started; Installer Guide
- Page 16 – Read all of the instructions before starting the instal-; C. Tools and Supplies Needed; Hearth & Home Technologies disclaims any responsibility for,; Any such action may cause a fi re hazard.; DO NOT use this appliance if any part has been under; Improper installation, adjustment, alteration, service or
- Page 17 – Framing and Clearances; A. Selecting Appliance Location; When selecting a location for the appliance it is important to; It is important to follow the framing and fi nishing instruc-
- Page 18 – B. Constructing the Appliance Chase; ltration barriers
- Page 19 – DO NOT install directly; oor; MINIMUM FRAMING DIMENSIONS*; Inches
- Page 20 – D. Mantel and Wall Projections; Comply with all minimum clear-
- Page 22 – A. Vent Termination Minimum Clearances; Termination Locations; DO NOT; pack air space with insulation or other
- Page 23 – regulator; public; Covered Alcove Applications; Termination caps are HOT,; NOT
- Page 24 – WARNING! Risk of Fire or Asphyxiation.; Vent Information and Diagrams; D. Measuring Standards; tion caps are NOT approved for use with propane fuel.; Effective
- Page 25 – reduction in total H when using; termination caps are not approved for use with pro-
- Page 26 – Top Vent - Horizontal Termination
- Page 28 – INSTALLED
- Page 29 – If installing a vertical vent/termination off the top of the; Top Vent - Vertical Termination; Exhaust restrictor Instructions; sual; PILOT HOLES; Before painting, contact your dealer for
- Page 33 – Coaxial to Colinear Venting; built; CLEARANCE TO COMBUSTIBLES REQUIREMENTS; Exhaust Vent Pipe; CAUTION! DO NOT use any fl
- Page 34 – To minimize cold air; adapter; Do NOT connect this gas appliance to a chimney; To achieve optimum per-; CAUTION! DO NOT use any fl
- Page 35 – A. Pipe Clearances to Combustibles; Maintain air space clearance to; Vent Clearances and Framing; B. Wall Penetration Framing; Combustible Wall Penetration; air in; Non-Combustible Wall Penetration
- Page 36 – C. Install the Ceiling Firestop; MUST; lation around the vent. Insulation must be kept
- Page 37 – D. Install Attic Insulation Shield; Flat Ceiling Installation; Vaulted Ceiling Installation
- Page 38 – Wear protective gloves and safety glasses during instal-; Appliance Preparation; If venting with a 90 degree elbow directly off of the top of
- Page 39 – B. Securing and Leveling the Appliance; Prevent contact with:
- Page 40 – A. Assemble Vent Sections; rating; WARNING! Risk of Fire or Explosion!; then rotate counterclockwise to lock
- Page 41 – C. Secure The Vent Sections; DO NOT allow vent to sag below; B. Assemble Slip Sections; the outer; Pilot hole; • Apply a bead of silicone sealant inside the female outer
- Page 42 – D. Disassemble Vent Sections; E. Install Decorative Ceiling Components
- Page 43 – F. Install Metal Roof Flashing; G. Assemble and Install Storm Collar; Failure to properly caulk the roof; CAULK
- Page 44 – H. Install Vertical Termination Cap; Heat shields may not be fi eld constructed.; J. Heat Shield Requirements for Horizontal; To prevent overheating and
- Page 45 – When using termination caps with factory-supplied heat; K. Install Horizontal Termination Cap
- Page 46 – Gas Information; Gas Pressure; Access Through the Valve Assembly; nishing
- Page 47 – D. High Altitude Installations; Valve Pressure Taps; The manifold and inlet pressure tabs can be ac-; PRESSURE TAPS; • If substituting for these components, please consult
- Page 48 – A. Wiring Requirements; National Electric Code; B. IntelliFire Ignition System Wiring; WARNING! Risk of Shock or Explosion! DO NOT; C. Optional Accessories Requirements; Electrical Information; Optional Remote Control Receiver and Battery Pack; the; CONTROL; optional remote receiver adjacent to battery
- Page 49 – E. Junction Box Installation; D. Electrical Service and Repair; Label all wires prior to dis-; There is an alternative access to the junction box.
- Page 50 – Finishing; A. Framing and Finishing Instructions; Finishing Instructions; or use of materials not meeting the ASTM E 136 standard; Non-Combustible Materials Specifi cation; Setting the Fireplace into the Framing; this
- Page 51 – CAUTION! Risk of Glass Damage and Cuts!; Note: It is acceptable to use a silicone sealant with a; Refer to Section 13.C regarding installation details
- Page 52 – that the; FIREPLACE OPENING; Finish and Sealing Joints; Painting
- Page 53 – B. Mantel and Wall Projections
- Page 54 – Non-Combustible Finish Materials; air
- Page 55 – The Tonic decorative front is approved for inside fi t ap-
- Page 56 – D. Decorative Fronts; A decorative front is required; Inside and Overlap Fit; The tinted glass on the Martini Decorative Front meets the; Table 1. Dimensions of Tonic Decorative Front.
- Page 57 – Contact your dealer; Appliance Setup; E. Glass Rock Media Kit; Cleaning the Glass Rock Media; into the; Installation; Delayed Ignition Risk
- Page 58 – PILOT SHIELD
- Page 59 – H. Air Shutter Setting; F. Fixed Glass Assembly; DO NOT operate; Removing Fixed Glass Assembly; Air Shutter Settings; NG
- Page 60 – A. IntelliFire Ignition System; Symptom; is; Troubleshooting
- Page 61 – ame
- Page 62 – Reference Materials; A. Appliance Dimension Diagram; Location Inches
- Page 63 – B. Vent Components Diagrams
- Page 66 – HORIZONTAL TERMINATION CAP; termination caps are not approved for use with
- Page 67 – Flex Liner Kit; COAXIAL to COLINEAR VENTING; Optional Wire Harness; Power Vent Inline
- Page 68 – D. Contact Information; For the location of your nearest Heat & Glo dealer,; DO NOT DISCARD THIS MANUAL; NOTICE
Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11
1
Model:
SLR-B (COSMO)
•
DO NOT
store or use gasoline or other
fl am-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
-
DO NOT
try to light any appliance.
-
DO NOT
touch any electrical switch.
DO
NOT
use any phone in your building.
- Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppli-
er’s instructions.
- If you cannot reach your gas supplier, call
the
fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.
Owner’s Manual
Installation and Operation
DO NOT DISCARD THIS MANUAL
NOTICE
This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions
and the manufactured home construction and safety standard,
Title 24 CFR, Part 3280
or
Standard for Installation in Mobile
Homes, CAN/CSA Z240MH, in Canada.
This appliance is only for use with the type(s) of gas indicated
on the rating plate.
Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.
• Leave this manual with
party responsible for use
and operation.
DO NO
T
DISCARD
WARNING
• Important operating
a n d m a i n t e n a n c e
instructions included.
• Read, understand and follow
these instructions for safe
installation and operation.
In the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fi tter.
See Table of Contents for location of additional Commonwealth
of Massachusetts requirements.
This appliance has been supplied with an integral barrier
to prevent direct contact with the
fi
xed glass panel. DO
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
HOT SURFACES
!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
•
DO NOT
touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• Keep clothing, furniture, draperies and other fl
ammable
materials away.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11 2 Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ Location on fi replace: _____________________ Dealership...
Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11 3 Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates ...
Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11 5 B. Limited Lifetime Warranty 4021-645C 12-29-10 Page 1 of 2 Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, ...
