Heat & Glo 8000TVC - Manual

Heat & Glo 8000TVC

Heat & Glo 8000TVC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
Page: / 31

Table of Contents:

  • Page 2 – SAFETY AND WARNING INFORMATION
  • Page 3 – Section 4: Maintaining and Servicing; i i
  • Page 4 – Appliance Certification; CERTIFICATION; Installation Codes; Approvals
  • Page 5 – Preparation; Installers
  • Page 7 – Clearance Requirements; The top, back, and sides of the fireplace are defined; Locating the; The diagram below shows space and clearance; Installing the
  • Page 8 – CAUTION; MEASURE FIREPLACE DIMENSIONS, AND; Framing the; Negative
  • Page 10 – A. Vent System Approvals
  • Page 11 – MINIMUM VERTICAL RISE = 9FT; Consult Local Building Code Officials and Codes for
  • Page 13 – Standing Pilot Ignition
  • Page 14 – Figure 8. Gas Controls Systems
  • Page 16 – Figure 9. Gas Supply Line; Gas Pressure; Pressure
  • Page 17 – For Standing Pilot Ignition Wiring; LABEL ALL WIRES PRIOR TO DISCONNECTION; Wiring the
  • Page 18 – NOTE; Electrical wiring must be installed by a licensed electrician.
  • Page 20 – IF JOINTS BETWEEN THE FINISHED WALLS; Hearth Extensions; Finishing
  • Page 21 – Ember Material
  • Page 22 – Lift the trim door up; Figure 15. Glass Assembly; material onto the top; Figure 16. Placement of the Ember Material; IT IS STRONGLY RECOMMENDED THAT TRIM
  • Page 23 – Lighting the
  • Page 24 – IMPORTANT; TURN OFF THE GAS BEFORE SERVICING
  • Page 25 – Figure 17. Burner Flame Patterns
  • Page 26 – All parts listed in this; INSTALLERS GUIDE; may be; Standing Pilot Only
  • Page 27 – DSI Ignition Only; PART; DSI Module
  • Page 28 – Both Standing Pilot and DSI Ignition
  • Page 31 – Accessories
Loading the manual

- Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any

other appliance.

-

What to do if you smell gas

• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a

neighbor's phone. Follow the gas supplier's

instructions.

• If you cannot reach your gas supplier, call the

fire department.

- Installation and service must be performed by a

qualified installer, service agency, or the gas

supplier.

Heat-N-Glo

Model:

8000TVC

Installers Guide

WARNING: IMPROPER

INSTALLATION, ADJUSTMENT,

ALTERATION, SERVICE OR

MAINTENANCE CAN CAUSE INJURY

OR PROPERTY DAMAGE. REFER TO

THIS MANUAL. FOR ASSISTANCE OR

ADDITIONAL INFORMATION

CONSULT A QUALIFIED INSTALLER,

SERVICE AGENCY, OR THE GAS

SUPPLIER.

258-900C 10/99

READ THIS MANUAL BEFORE INSTALLING

O R O P E R AT I N G T H I S A P P L I A N C E . T H I S

INSTALLERS GUIDE

MUST BE LEFT WITH

THE APPLIANCE FOR FUTURE REFERENCE.

Please contact your Heat-N-Glo dealer with

any questions or concerns. For the number

of your nearest Heat-N-Glo dealer, please

call 612-985-6000.

Printed in U.S.A. Copyright 1999,

Heat-N-Glo, a division of Hearth Technologies Inc.

20802 Kensington Blvd., Lakeville, MN 55044

T h i s p r o d u c t i s c o v e r e d b y o n e o r m o r e o f t h e f o l l o w i n g p a t e n t s : ( U n i t e d S t a t e s ) 4 , 1 1 2 , 9 1 3 ; 4 , 4 0 8 , 5 9 4 ; 4 , 4 2 2 , 4 2 6 ; 4 , 4 2 4 , 7 9 2 ; 4 , 5 2 0 , 7 9 1 ; 4 , 7 9 3 , 3 2 2 ;
4 , 8 5 2 , 5 4 8 ; 4 , 8 7 5 , 4 6 4 ; 5 , 0 0 0 , 1 6 2 ; 5 , 0 1 6 , 6 0 9 ; 5 , 0 7 6 , 2 5 4 5 , 1 9 1 , 8 7 7 ; 5 , 2 1 8 , 9 5 3 ; 5 , 3 2 8 , 3 5 6 ; 5 , 4 2 9 , 4 9 5 ; 5 , 4 5 2 , 7 0 8 ; 5 , 5 4 2 , 4 0 7 ; 5 , 6 1 3 , 4 8 7 ; ( A u s t r a l i a )
5 4 3 7 9 0 ; 5 8 6 3 8 3 ; ( C a n a d a ) 1 , 1 2 3 , 2 9 6 ; 1 , 2 9 7 , 7 4 6 ; 2 , 1 9 5 , 2 6 4 ; ( M e x i c o ) 9 7 - 0 4 5 7 ; ( N e w Z e a l a n d ) 2 0 0 2 6 5 ; o r o t h e r U . S . a n d f o r e i g n p a t e n t s p e n d i n g .

Underwriters

Laboratories Listed

WARNING

IF THE INFORMATION IN THESE

INSTRUCTIONS IS NOT

FOLLOWED EXACTLY, A FIRE OR

EXPLOSION MAY RESULT

CAUSING PROPERTY DAMAGE,

PERSONAL INJURY, OR DEATH.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - SAFETY AND WARNING INFORMATION

SAFETY AND WARNING INFORMATION READ and UNDERSTAND all instructions carefully before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty. Prior to the first firing of the fireplace, READ the Using Your Fireplace...

Page 3 - Section 4: Maintaining and Servicing; i i

Table of Contents Safety and Warning Information .......................... i Section 1: Approvals and Codes ...................... 1 Approval Listings and Codes ..................................... 1Appliance Certification ............................................... 1Installation Codes ..........

Page 4 - Appliance Certification; CERTIFICATION; Installation Codes; Approvals

1 Approval Listings and Codes Appliance Certification The Heat-N-Glo fireplace models discussed in this Installers Guide have been tested to certification standards and listed by the applicable laboratories. CERTIFICATION MODEL LABORATORY TYPE STANDARD 8000TVC Underwriters Vented ANSI Z21.50•CGA2.2 ...

Other Heat & Glo Models

All Heat & Glo Other