Heat & Glo 6000TRS-CD - Manual
Heat & Glo 6000TRS-CD – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SAFETY AND WARNING INFORMATION; Users Guide; ALERTED; Installers Guide
- Page 3 – Positioning, Leveling and; Section 4: Maintaining and Servicing
- Page 4 – Log Set Assembly; Service Parts
- Page 5 – ACCESSORIES
- Page 6 – Standing Pilot; ITEM
- Page 7 – Appliance Certification; The Heat & Glo fireplace models discussed in this; CERTIFICATION; 000TRS-CE Advantica; Installation Regulations
- Page 8 – Do
- Page 10 – Space Requirements; Clearance Requirements; RECESSED DEPTH; Minimum Clearances from the Fireplace to Combustible Materials; Figure 3. Minimum Clearances; Minimum Clearances from the Flue Pipe to Combustible Materials
- Page 11 – NOTE; taken; Figure 4. Framing Dimensions; CAUTION
- Page 12 – A. Flue System Approvals; Installers; Flue system termination kits
- Page 13 – NOTE: PIPES OVERLAP 32 mm AT EACH JOINT.
- Page 14 – Figure 7. Straight up Vertical Flue; STRAIGHT OUT HORIZONTAL FLUE
- Page 15 – Figure 10. Flue with One 90° Elbow; will allow the flue pipe to clear the top standoffs.; ELBOW
- Page 16 – Figure 11. Flue with Two 90° Elbows
- Page 17 – Figure 12. Flue with Two 90° Elbows
- Page 18 – Figure 13. Flue with three 90° elbows
- Page 19 – Figure 14. Flue with three 90° elbows
- Page 20 – B. Installing Flue Components; Venting Out the Rear Flue; Venting
- Page 23 – REQUIRED; FIGURE 19. Hole and New Framing Members
- Page 24 – NOT; FIGURE 21. Attic Firestop; IS
- Page 25 – FIGURE 22. Venting through the Wall
- Page 26 – FIGURE 23 DVP Termination Cap
- Page 27 – Roof Pitch; Figure 24. Minimum Height from Roof to Lowest
- Page 28 – Alcove Applications
- Page 29 – Figure 27. Gas Control System; Place the fireplace; Securing of a Fireplace
- Page 31 – Inlet Pressure; Optional Accessories
- Page 32 – Figure 29. Standing Pilot Ignition Wiring Diagram
- Page 33 – overlap onto the front face.; Figure 32. Holding Tabs
- Page 34 – Carefully remove the logs from the packaging.
- Page 37 – The fireplace should be run for 3 to 4 hours on the
- Page 38 – IMPORTANT
- Page 39 – Figure 35. Burner Flame Patterns; MAKE SURE THE FLAMES; Figure 36. Pilot Flame Patterns
- Page 40 – Standing Pilot Troubleshooting; Symptom; The pilot will not stay; Possible Cause; b. Defective pilot or; Corrective Action
- Page 41 – orifice
-
Do not store or use petrol or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
-
What to do if you smell gas
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier’s instructions
• If you cannot reach your gas supplier,
call the fire department.
-
Installation and service must be performed
by a qualified installer or competent
person.
Model:
6000TRS-CE
Installers Guide
WARNING: IMPROPER INSTALLATION,
ADJUSTMENT, ALTERATION, SERVICE
OR MAINTENANCE CAN CAUSE INJURY
OR PROPERTY DAMAGE. REFER TO
THIS MANUAL. FOR ASSISTANCE OR
ADDITIONAL INFORMATION CONSULT A
QUALIFIED INSTALLER OR
COMPETENT PERSON.
2049-900H 10/06
READ THIS MANUAL BEFORE INSTALLING OR
OPERATING THIS APPLIANCE. THIS
INSTALLERS
GUIDE
MUST BE LEFT WITH APPLIANCE FOR
FUTURE REFERENCE.
Please contact your Heat & Glo dealer with any
questions or concerns. For the number of your nearest
Heat & Glo dealer, please visit www.heatnglo.com.
Printed in U.S.A. Copyright 2005
Heat & Glo, a brand of Hearth & Home Technologies Inc.
20802 Kensington Blvd., Lakeville, MN 55044, USA
These instructions are only valid if the
following country symbol is on the appliance.
If this symbol is not present on the appliance,
it is necessary to refer to the technical
instructions which will provide the necessary
information concerning the modification of the
appliance to the conditions of use for the
country.
0087
These instructions are valid for the following
countries: GB, IE
WARNING:
IF THE INFORMATION IN THESE
INSTRUCTIONS IS NOT
FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
T h i s p r o d u c t i s c o v e r e d b y o n e o r m o r e o f t h e f o l l o w i n g pa t e n ts : ( U n i t e d Sta t e s ) 4 , 11 2 , 9 1 3 ; 4 , 4 0 8 , 5 9 4 ; 4 , 4 2 2 , 4 2 6 ; 4 , 4 2 4 , 7 9 2 ; 4 , 5 2 0 , 7 9 1 ; 4 , 7 9 3 , 3 2 2 ;
4 , 8 5 2 , 5 4 8 ; 4 , 8 7 5 , 4 6 4 ; 5 , 0 0 0 , 1 6 2 ; 5 , 0 1 6 , 6 0 9 ; 5 , 0 7 6 , 2 5 4 5 , 1 9 1 , 8 7 7 ; 5 , 2 1 8 , 9 5 3 ; 5 , 3 2 8 , 3 5 6 ; 5 , 4 2 9 , 4 9 5 ; 5 , 4 5 2 , 7 0 8 ; 5 , 5 4 2 , 4 0 7 ; 5 , 6 1 3 , 4 8 7 ; ( A u s t r a l i a )
5 4 3 7 9 0 ; 5 8 6 3 8 3 ; ( C a n a d a ) 1 , 1 2 3 , 2 9 6 ; 1 , 2 9 7 , 7 4 6 ; 2 , 1 9 5 , 2 6 4 ; ( M e x i c o ) 9 7 - 0 4 5 7 ; ( N e w Z e a l a n d ) 2 0 0 2 6 5 ; o r o t h e r U . S . a n d f o r e i g n p a t e n t s p e n d i n g .
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 ! SAFETY AND WARNING INFORMATION READ and UNDERSTAND all instructions carefully before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty. Prior to the first firing of the fireplace, READ the Using Your Firep...
3 Table ofContents Safety and Warning Information .................................. 2 Service Parts List ......................................................... 4 Section 1: Approvals and Regulations ....................... 7 Appliance Certification ..................................................
4 * Part number list on following page. 9 Log Set Assembly (NG, LP) Exploded Parts Diagram Service Parts 6000TRS-CE Beginning Manufacturing Date: 1/04Ending Manufacturing Date: ______ 2 3 4 6 8 7 15 1 5 10 11 12 13 14 19 20 17 16 18
