Heat & Glo 6000CMOD-IPI - Manual

Heat & Glo 6000CMOD-IPI

Heat & Glo 6000CMOD-IPI – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
Page: / 71

Table of Contents:

  • Page 2 – Listing Label Information/Location; This owner ’s manual; Homeowner Reference Information; Read this manual before installing or operating this appliance.; Serial Number; NA; XXXXXXXX
  • Page 3 – Safety Alert Key:; • NOTICE: Used to address practices not related to personal injury.; Table of Contents; User Guide
  • Page 4 – 6 Reference Materials
  • Page 5 – B. Limited Lifetime Warranty; LIMITED LIFETIME WARRANTY
  • Page 6 – This warranty is void if:; QRWOLPLWHGWRLPSURSHUFKLPQH\RUYHQWLQJLQVWDOODWLRQ; LIMITATIONS OF LIABILITY:; DWLRQRIJODVV
  • Page 7 – TYPE: Direct Vent Gas Appliance Heater; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.; Listing and Code Approvals; Models
  • Page 8 – T h e f o l l o w i n g r e q u i r e m e n t s r e f e r e n c e va r i o u s
  • Page 9 – A. Gas Fireplace Safety; WARNING; HOT SURFACES; touch glass until it is cooled; Operating Instructions
  • Page 10 – Assembly; For specifi c information on fi replace controls, see Section 12.
  • Page 11 – Nine Hour Safety Shutdown Feature; J. Before Lighting Fireplace; have a; H. IPI Battery Tray/Battery Installation; I. Control Module Operation; Module Reset
  • Page 12 – NOT FOR USE; Final inspection by
  • Page 13 – ISSUE
  • Page 14 – Glass Cleaning; Tools Needed; • Avoid striking, scratching or slamming glass; Tools needed; Maintenance and Service; Remote Control
  • Page 15 – Interior Ceramic Glass Panel Cleaning; Firebox
  • Page 16 – Valve Assembly Removal; Remove the base pan by removing the screws circled; APPEARANCE
  • Page 17 – D. Burner Identifi cation
  • Page 18 – A. Typical Appliance System; Getting Started; Installer Guide
  • Page 19 – Read all of the instructions before starting the instal-; C. Tools and Supplies Needed; • Installation and use of any damaged appliance or vent; Any such action may cause a fi re hazard.
  • Page 20 – Framing and Clearances; A. Selecting Appliance Location; Mantel Projections
  • Page 21 – B. Constructing the Appliance Chase; • Insulation and other materials must be secured to prevent
  • Page 22 – D. Mantel and Wall Projections; Combustible Mantels; Measurement is taken from top of the
  • Page 23 – A. Vent Termination Minimum Clearances; Termination Locations; DO NOT; pack air space with insulation or other
  • Page 24 – public; Covered Alcove Applications; NOT
  • Page 25 – mix pipe, fi ttings or joining methods from differ-; Vent Information and Diagrams; D. Measuring Standards; • Pipe measurements are shown using the effective length; Horizontal
  • Page 27 – Two Elbows; Minimum
  • Page 28 – Three Elbows; Elbow only
  • Page 29 – Top Vent - Vertical Termination; If installing a vertical vent/; Break the fl ue restrictor into two pieces. Do this by; BREAK; Flue Restrictor Instructions; Install fl ue restrictor as shown below.
  • Page 30 – Center the Flue Restrictor on vent and secure in place; Restrictor; Maximum; Note; Top vent 40 ft vertical with DVP pipe = 4-4
  • Page 31 – Minimum H
  • Page 32 – A. Pipe Clearances to Combustibles; Vent Clearances and Framing; B. Wall Penetration Framing; Combustible Wall Penetration; • The opening must be framed on all four sides using the; Non-Combustible Wall Penetration
  • Page 33 – C. Install the Ceiling Firestop; A ceiling fi restop; MUST; be used between; DVP pipe only; • Frame the area with the same sized lumber
  • Page 34 – D. Install Attic Insulation Shield; Flat Ceiling Installation; Gas Kit; Vaulted Ceiling Installation
  • Page 35 – Appliance Preparation
  • Page 36 – C. Securing and Leveling the Appliance
  • Page 37 – Attach Vent to the Firebox Assembly; The end of the pipe sections with the lanced tabs will face; Assemble Pipe Sections; Make sure that the seams are not aligned to prevent; INCORRECT; Lances
  • Page 38 – C. Assemble Slip Sections; Pilot hole; • Apply a bead of silicone sealant inside the female outer
  • Page 39 – E. Disassemble Vent Sections
  • Page 40 – F. Install Decorative Ceiling Components
  • Page 41 – G. Install Metal Roof Flashing; H. Assemble and Install Storm Collar; CAULK
  • Page 42 – I. Install Vertical Termination Cap; • Slide the decorative wall thimble over the last section of; Heat shields may not be fi eld constructed.; K. Heat Shield Requirements for Horizontal; • DO NOT remove the heat shields attached to the
  • Page 43 – L. Install Horizontal Termination Cap (DVP; Cap Specifi cation Chart
  • Page 44 – • Purge should be performed by qualified service; Gas Information; Gas Pressure; • If substituting for these components, please consult; D. High Altitude Installations
  • Page 45 – A. Wiring Requirements; Ignition System Wiring; Electrical Information; C. Optional Accessories Requirements
  • Page 46 – E. Junction Box Installation; INSIDE; D. Electrical Service and Repair
  • Page 47 – Finishing; A. Mantel and Wall Projections; Measurement is taken from top of the opening,
  • Page 48 – inches; C. Finish and Sealing Joints; Finishing Around Opening with Gypsum Wallboard
  • Page 49 – ATED HEARTH; Folio Door Application; be used. The CMOD door; CMOD Door Application
  • Page 51 – Finishing Material Thickness Greater than 1 Inch
  • Page 52 – Appliance Setup; E. Glass Panel Installation; Screw the three glass panel retainers to the fi re-
  • Page 53 – REMOVE SCREW; THIS JIG MUST BE USED FOR
  • Page 54 – NO MEDIA ON
  • Page 55 – G. Fixed Glass Assembly; Removing Fixed Glass Assembly; Air Shutter Settings; I. Air Shutter Setting; NG; Fully Closed
  • Page 56 – Troubleshooting; Ignition System; Symptom
  • Page 57 – A. A shorted or loose connection in fl ame
  • Page 58 – Reference Materials; A. Appliance Dimension Diagram; Location Inches
  • Page 60 – B. Vent Components Diagrams
  • Page 61 – Horizontal Termination Cap; Max; The heat shield is designed to be; Heat
  • Page 63 – High Performance Cap
  • Page 64 – HORIZONTAL TERMINATION CAP; Optional Wire Harness; Power Vent Inline
  • Page 65 – Effective Height/Length
  • Page 67 – Beginning Manufacturing Date: Aug 2010; 6” Modern Direct Vent Fireplace; Stocked; ITEM
  • Page 68 – 2” Modern Direct Vent Fireplace
  • Page 69 – Beginning Manufacturing Date: Aug 2009
  • Page 70 – Gasket Assembly
  • Page 71 – D. Contact Information; For the location of your nearest Heat & Glo dealer,; DO NOT DISCARD THIS MANUAL; NOTICE; • Leave this manual with
Loading the manual

1

Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12

•

DO NOT

store or use gasoline or other fl am-

mable vapors and liquids in the vicinity of this
or any other appliance.

• What to do if you smell gas

-

DO NOT

try to light any appliance.

-

DO NOT

touch any electrical switch.

DO

NOT

use any phone in your building.

- Immediately call your gas supplier from a

neighbor’s phone. Follow the gas suppli-
er’s instructions.

- If you cannot reach your gas supplier, call

the fi re department.

• Installation and service must be performed

by a qualifi ed installer, service agency, or the
gas supplier.

WARNING: If the information in these

instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.

Owner’s Manual

Installation and Operation

DO NOT DISCARD THIS MANUAL

NOTICE

This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions
and the manufactured home construction and safety standard,

Title 24 CFR, Part 3280

or

Standard for Installation in Mobile

Homes, CAN/CSA Z240MH, in Canada.

This appliance is only for use with the type(s) of gas indicated
on the rating plate.

Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.

• Leave this manual with

party responsible for use
and operation.

DO NO

T

DISCARD

WARNING

• Important operating

a n d m a i n t e n a n c e
instructions included.

• Read, understand and follow

these instructions for safe
installation and operation.

In the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fi tter.

See Table of Contents for location of additional Commonwealth
of Massachusetts requirements.

This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.

Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.

HOT SURFACES

!

Glass and other surfaces are hot during
operation AND cool down.

Hot glass will cause burns.

•

DO NOT

touch glass until it is cooled

• NEVER allow children to touch glass
• Keep children away

• CAREFULLY SUPERVISE children in same room as

fi replace.

• Alert children and adults to hazards of high temperatures.

High temperatures may ignite clothing or other fl ammable
materials.

• Keep clothing, furniture, draperies and other fl ammable

materials away.

Models:
6000CMOD-IPI
8000CMOD-IPI

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Listing Label Information/Location; This owner ’s manual; Homeowner Reference Information; Read this manual before installing or operating this appliance.; Serial Number; NA; XXXXXXXX

Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12 2 Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ Location on fi replace: ___________...

Page 3 - Safety Alert Key:; • NOTICE: Used to address practices not related to personal injury.; Table of Contents; User Guide

3 Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12 Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. •...

Page 4 - 6 Reference Materials

Heat & Glo • 6000CMOD-IPI, 8000CMOD-IPI • 2241-900 Rev. H • 5/12 4  = Contains updated information. 13 Finishing A. Mantel and Wall Projections . . . . . . . . . . . . . . . . . . . . . . . 47B. Facing Material . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48C. Finish and Se...

Other Heat & Glo Models

All Heat & Glo Other