Heat & Glo 36DV - Manual
Heat & Glo 36DV – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installers Guide; DO NOT; Owners Guide; ALERTED; SAFETY AND WARNING INFORMATION
- Page 3 – TABLE OF CONTENTS
- Page 4 – Log set assembly; Service Parts
- Page 5 – ACCESSORIES / ACCESSOIRES; Service Parts List / Liste des pièces de rechange; L'information fournie dans cette brochure
- Page 6 – Appliance Certification; The Heat-N-Glo fireplace model discussed in this; Certification; Underwriters Laboratories; Installation Codes
- Page 7 – Getting Started; Introducing the Heat-N-Glo Gas Fireplaces; Pre-install Preparation; Do not install any
- Page 9 – Installing the Fireplace; Step 1. Locating the Fireplace; Vertical Sections; Constructing the Fireplace Chase; TREATMENT OF FIRESTOP SPACERS AND
- Page 10 – Framing Dimensions; Step 2. Framing the Fireplace; MEASURE FIREPLACE DIMENSIONS AND; Clearance to an exposed combustible hearth extension; Clearance to Hearth Extension; (4” Minimum to top surface of combustible floor or floor covering).
- Page 12 – Step 3. Installing the Vent System; WALL FIRESTOP
- Page 13 – Flue Restrictor Instructions; Figure 10. Flue Restrictor; DIAMETER; Figure 9; NG; STRAIGHT UP; VERTICAL VENTING; On vertical venting
- Page 14 – Figure 12. Venting with Two 90° Elbows; H + H; VENTING WITH; Must have a 12”
- Page 15 – Figure 13. Venting with three 90° elbows
- Page 16 – B. Installing Vent Components
- Page 18 – = AREA WHERE TERMINAL IS NOT PERMITTED; Figure 20. Vent Termination Minimum Clearances; public; NOT
- Page 20 – Step 5. Installing the Optional Heat-Zone Kit; Do this; FORE; final positioning of the fireplace.; Step 6 The Gas Control System; The type of gas control system used with this model is; Intermittent Pilot Ignition System
- Page 21 – Pressure
- Page 22 – Step 9. Wiring the Fireplace; Ignition module, valve, pilot and wall switch operate on 3 volts.; Back light must be wired to a separate 110-120 VAC wall switch.
- Page 23 – Figure 27. Sealant Material; Height above opening
- Page 24 – Facing Requirements; Positioning the Logs
- Page 25 – Step 12. Before Lighting the Fireplace; Step 13. Lighting the Fireplace
- Page 26 – Maintaining and Servicing Your Fireplace; Fireplace Maintenance; Placing the Ember Material
1
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
-
What to do if you smell gas
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
Installers Guide
W A R N I N G : I M P R O P E R I N S TALLA-
TION, A D J U S T M E N T, ALT E R ATION,
S E R V I C E O R M A I N T E N A N C E C A N
CAUSE INJURY OR PROPERTY DAM-
AGE. REFER TO THIS MANUAL. FOR
ASSISTANCE OR ADDITIONAL INFOR-
MATION CONSULT A QUALIFIED IN-
STALLER, SERVICE AGENCY, OR THE
GAS SUPPLIER.
Underwriters
Laboratories Listed
2012-900E
11/03
READ THIS MANUAL BEFORE INSTALLING OR
OPERATING THIS APPLIANCE. THIS
INSTALLERS
GUIDE
MUST BE LEFT WITH APPLIANCE FOR
FUTURE REFERENCE.
1. This appliance may be installed in an af-
termarket, permanently located, manufac-
tured (mobile) home, where not prohibited
by local codes.
2. This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certified kit is used.
Please contact your Heat-N-Glo dealer with any
questions or concerns. For the number of your nearest
Heat-N-Glo dealer, please call 1-888-427-3973.
Printed in U.S.A. Copyright 2003,
Heat-N-Glo, a brand of Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044
WARNING: IF THE INFORMATION
IN THESE INSTRUCTIONS IS NOT
FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUS-
ING PROPERTY DAMAGE, PER-
SONAL INJURY, OR DEATH.
This product is covered by one or more of the following patents: (United States) 4,112,913; 4,408,594; 4,422,426; 4,424,792; 4,520,791; 4,793,322;
4,852,548; 4,875,464; 5,000,162; 5,016,609; 5,076,254 5,191,877; 5,218,953; 5,328,356; 5,429,495; 5,452,708; 5,542,407; 5,613,487; (Australia)
543790; 586383; (Canada) 1,123,296; 1,297,746; 2,195,264; (Mexico) 97-0457; (New Zealand) 200265; or other U.S. and foreign patents pending.
Model:
Escape-36DV
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 These units MUST use one of the vent systems described in the Installing the Fireplace section ofthe Installers Guide . NO OTHER vent systems or components M AY BE USED . This gas fireplace and vent assembly MUST be vented directly to the outside and MUST NEVER be attached to a chimney serving a s...
3 TABLE OF CONTENTS Safety and Warning Information ................................................. 2 Service Parts Lists ...................................................................... 4 Section 1: Approvals and Codes ................................................ 6 Appliance Certificatio...
4 * Part number list on following page. * La liste des numéros de pièce se trouve à la page suivante. 12 Log set assembly (NG, LP) Exploded Parts Diagram(GN, PL) Vue éclatée des pièces Service Parts ESCAPE-36DV Beginning Manufacturing Date: 9-03 Ending Manufacturing Date: ______ 11 9 10 1 3 5 2 6 4 ...
