Havis-Shields P-MFK-5 - Manual
Havis-Shields P-MFK-5 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Always; Use hardware provided with install kit; “B” PILLAR MOUNTING BRACKET:
- Page 3 – Plastic trim panel must be notched around bracket to mount.; ATTACH PASSENGER SIDE MOUNTING BRACEKT:; Tighten all hardware.; Passenger side upper
- Page 4 – Position on front row bench in van close side doors.; Driver side upper lexan filler
INSTALL INSTRUCTIONS P-MID-1 w/P-MFK-5
MIDDLE PARTITION w/MOUNTING FILLER PANEL KIT
1997-2008 CHEVROLET/GMC FULL SIZE PASSENGER VANS
TOOLS REQUIRED:
Power
drill
Drill bit set
Ratcheting wrench
Standard & Metric socket set
HARDWARE:
QTY DESCRIPTION PART
#
5
¼” x 1 ½” Hex head Lag Bolt
GSM33062
6
¼” x 1” Hex head Lag Bolt
GSM33060
20
¼-20 x ¾” Carriage Bolt
GSM32000
12
¼-20 Serrated Nut
GSM30023
8
¼-20 Nylock Nut
GSM30016
1
5/16-18 Nylock Nut
GSM30017
1
5/16-18 x 2” Hex Head Bolt
GSM33015
2
5/16 Flat Washer
GSM31006
8
¼” x 1” Fender Washer
GSM31014
Main Partition
Frame
Driver Side Upper
Lexan Filler Panel
Upper Center Steel
Filler Panel
Driver Side Lower
Steel Filler Panel
Passenger Side Steel
Door Filler Panel
Passenger Side
Mounting Bracket
(2-Piece) Driver Side
“B” Pillar Mounting
Bracket
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P-MID-1^MFK-5_INST_9-07 SUB ASSEMBLY: 1. Remove “C” pillar trim panel. This is necessary for driver side mounting bracket. 2. Position upper center filler to partition and mark mounting holes. 3. Drill 5/16” holes on marks. Always ! Read all instructions before installing any Havis-Shields Equipment...
P-MID-1^MFK-5_INST_9-07 serrated nuts. • Press partition as far forward and mark mounting holes where driver side mounting bracket and “C-pillar” come in contact. • Pre-drill 3/16” holes into “C-pillar”. • Attach bracket to C-pillar using (3) ¼” x 1” Hex head lag bolts. • Plastic trim panel must be ...
P-MID-1^MFK-5_INST_9-07 5. ATTACH DRIVER SIDE UPPER LEXAN FILLER PANEL: • Position driver side ¼” lexan filler panel to partition so that minimal space is between the vehicles window, (or window guard) and the lexan filler. NOTE: It is necessary to keep a 1/8” gap between the window or guard and the...
