Havis-Shields KK-K9-F14-K-PT - Manual
Havis-Shields KK-K9-F14-K-PT – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FORD EXPEDITION K9/PT COMBO KIT
- Page 7 – grab handle is optional)
- Page 8 – Top Inner Screw; Bracket; Make sure guard is centered on window.
- Page 9 – Door panel
INSTALL INSTRUCTIONS KK-K9-F14-K-PT
K9/PRISONER TRANSPORTATION SYSTEM
2003-2009 FORD EXPEDITION
HARDWARE:
QTY: DESCRIPTION: PART
#:
28
¼-20 x ½” Stainless carriage bolt
GSM32022
8
¼-20 x ¾” Stainless carriage bolt
GSM32024
64
¼-20 flanged serrated nut
GSM30023
6
¼-20 x ¾” Hex head cap screw
GSM33001
6
¼” x 1 ½” Hex head lag screw
GSM33062
36
#12 x ¾” Stainless sheet metal screw
GSM34177
24
#10 x ¾” Stainless sheet metal screw
GSM34170
12
#10 x ½” Stainless sheet metal screw
GSM34169
10
10-32 x ¾” Stainless machine screw
GSM34098
6
#10 x ¾” Sheet metal screw
GSM33195
1
Tube silver caulk
PRM97343
1
46” x 45 ½” Rubber Floor mat
KNM01029-SUV
10
#10 x ½” Flat head sheet metal screw
GSM33150
1
¼” Lexan shield/PT front partition
KNM001220
Always
!
¾
Read all instructions before installing any Havis-Shields Equipment Corp products.
¾
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾
Use hardware provided with install kit
¾
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
1-800-524-9900.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
KK-K9-F14-K-PT_INST_11-08 2 FORD EXPEDITION K9/PT COMBO KIT Upper passenger side filler panel Rear passenger side filler panel Lower passenger side filler panel Rear floor mount bracket Front passenger side filler panel Floor mounting plates and legs Driver-side tunnel Upper “B”-pillar mounting brac...
KK-K9-F14-K-PT_INST_11-08 7 Attach “B” pillar mounting bracket to front partition using ¼” x ¾” carriage bolts and nuts Install “B” pillar mounting bracket using bolts that hold grab handle. (Re-installing the grab handle is optional) Grab handle removed Attach ceiling filler panel to front partitio...
8 KK-K9-F14-K-PT_INST_11-08 Pre-drill holes using 3/16” drill bit and attach using ¼”x 1” Lag bolts Attach rear partition to floor of vehicle. Location where ceiling filler bolts to rear partition Position floor filler panel to K9 housing, mark holes and pre-drill K9 housing using 1/8” drill bit Att...
