Harman R6 - Manual - manualsarea.com

Page 2 - Contents

2 Contents Manufactured by Harman Stove Company 352 Mountain House Road Halifax Pa. 17032 (717) 362-9080 Packing List 3 Installation & Assembly 3 Venting 5 Operation 9 ESP Control 12 Maintenance 13 Wiring Diagram 16 Feeder Parts 17 Trouble Shooting 18 Specifications 19 Warnings 20

Page 3 - Packing List; Assembly and Installation

3 Packing List Assembly and Installation Final Assembly Remove parts from ash pan.Install Wooden Door Handle with 1/4 x 20 x 2 1/2 bolt. Install Brass Hopper Knob with 10-32 x 1/2 bolt. Install the two Firebricks on the angle iron behind the burn pot asshown in fig. 1. Remove tape from Flame Guide a...

Page 4 - Installing

4 Installing Place the stove on a noncombustible floor pro- tector and away from combustible walls at least asfar as shown in figure 2 and 3. Note that the clear-ances shown are minimum for safety but do not leavemuch room for access when cleaning or servicing.Please take this into account when plac...

Page 5 - Venting; Vent Pipe; Outside Air

5 Venting A combustion blower is used to extract the com- bustion gases from the firebox. This causes a nega-tive pressure in the firebox and a positive pressure inthe venting system as shown in fig. 4. The longer thevent pipe and more elbows used in the system, thegreater the flow resistance. Becau...

Page 6 - KEEP COMBUSTIBLES (SUCH; CAUTION

6 #2 Preferred method This method also provides excellent venting for normal operation but requires the stove to be installedfarther from the wall. The vertical portion of the ventshould be three to five feet high and at least threeinches from a combustible wall. This vertical sectionwill provide na...

Page 9 - WARNING

9 DO NOT INSTALL A FLUE DAMPER IN THEEXHAUST VENTING SYSTEM OF THISUNIT. DO NOT CONNECT THIS UNIT TO ACHIMNEY FLUE SERVING ANOTHERAPPLIANCE. INSTALL VENT AT CLEARANCESSPECIFIED BY THE MANUFACTURER Mobile home installation should be done inaccordance with the Manufactured Home andSafety Standard (HUD...

Page 10 - Operation; Starting First Fire

10 Operation Starting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red powerlight on the control panel. Fill the hopper with pellets, fig. 12. Fill the burn pot with pellets to a level just short of overflowing, fig. 8. Adjust feed rate. If thi...

Page 13 - ESP CONTROL

13 ESP CONTROL Feed adjusterSets the maximum feedrate TestRuns all motors atfull speed for twominutes to checkoperation. After twominutes the stovewill go to minimumburn and the blowerswill alternate fromhigh to low every twominutes to remindyou that you are stillin "Test Mode". Distribution...

Harman R6 - Manual

Table of Contents:

Summary

Other Harman Models