Harman R6 - Manuals

5 Venting A combustion blower is used to extract the com- bustion gases from the firebox. This causes a nega-tive pressure in the firebox and a positive pressure inthe venting system as shown in fig. 4. The longer thevent pipe and more elbows used in the system, thegreater the flow resistance. Becau...

6 #2 Preferred method This method also provides excellent venting for normal operation but requires the stove to be installedfarther from the wall. The vertical portion of the ventshould be three to five feet high and at least threeinches from a combustible wall. This vertical sectionwill provide na...

9 DO NOT INSTALL A FLUE DAMPER IN THEEXHAUST VENTING SYSTEM OF THISUNIT. DO NOT CONNECT THIS UNIT TO ACHIMNEY FLUE SERVING ANOTHERAPPLIANCE. INSTALL VENT AT CLEARANCESSPECIFIED BY THE MANUFACTURER Mobile home installation should be done inaccordance with the Manufactured Home andSafety Standard (HUD...

10 Operation Starting First Fire Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red powerlight on the control panel. Fill the hopper with pellets, fig. 12. Fill the burn pot with pellets to a level just short of overflowing, fig. 8. Adjust feed rate. If thi...

13 ESP CONTROL Feed adjusterSets the maximum feedrate TestRuns all motors atfull speed for twominutes to checkoperation. After twominutes the stovewill go to minimumburn and the blowerswill alternate fromhigh to low every twominutes to remindyou that you are stillin "Test Mode". Distribution...