Grizzly Industrial h8234 - Manual

Model H8234 28° Framing Nailer -5 - introduction If you have any comments regarding this manual, please contact us: Grizzly Industrial, Inc. C/O Technical Documentation Manager P.O. Box 2069 Bellingham, WA 98227-2069 email: [email protected] Most importantly, we stand behind our tools. If you have...

Model H8234 28° Framing Nailer -6 - set up inventory After you open the nailer box, you should find the following. model h8234 inventory (figure 1) Qty a. 28° Framing Nailer ............................. 1b. Safety Goggles ................................. 1c. Oil ......................................

Model H8234 28° Framing Nailer -7 - The Model H8234 is designed to be oper-ated at 80-110 PSI using clean, dry, regu-lated, compressed air. do not exceed the 120 psi maximum operating pres-sure for your model. Before using your new nailer, regulate the air pressure to find the optimum setting within...

Model H8234 28° Framing Nailer -9 - operations loading When replacing nails in your model h8234, follow these guidelines: Nail Size ...................... 1 ⁄ 8 " Shank Diameter Nail Strip Angle ............... 28º Clipped HeadLength.............................................. 2"–3 1 ⁄ 2 &...

Model H8234 28° Framing Nailer -10 - 5. Pull the trigger. — If the nail drove into the wood far enough, continue with your intended operations. — If the nail either went too far or not far enough, then go to the adjusting depth section on this page. 3. Depress the safety nose mechanism against your ...

Model H8234 28° Framing Nailer -11 - A jammed nail must be cleared before using the nailer again. to clear a jammed nail from the dis-charge area: 1. DISCONNeCT NAILeR FROM THe AIR SUPPLY! 2. Pull back and latch the magazine push- er. 3. Remove the nail stick from the maga- zine. 4. Locate the openi...

Model H8234 28° Framing Nailer -12 - replacing pistons/o- rings Under heavy use, a piston, piston shaft, or O-ring may wear out. Replacement is quick and easy. Contact Grizzly Customer Service at (800) 523-4777 to obtain the Piston Repair Kit (Part Number PH8234092), or the complete O-Ring Repair Ki...

Model H8234 28° Framing Nailer -13 - accessories g2820 —pneumatic tool oil 8 oz.g2821—pneumatic tool oil 1 pintUse the right oil! This pneumatic tool oil offers outstanding heat displacement and friction reduction without eating away at delicate air components like detergent motor oils. Stock up wit...

Model H8234 28° Framing Nailer -14 - cleaning & lubrication cleaning Use non-flammable solvent to clean the nose assembly of the nailer. Always be sure that the nailer is dry before using it again. Do not allow dust, chips, sand, etc. into the air connectors or into the body of the nailer; this ...

Model H8234 28° Framing Nailer -17 - troubleshooting symptom possible cause solution Air leaking at trig-ger valve area. 1. O-rings in trigger valve hous- ing are damaged. 1. O-rings must be replaced & operation of safety nose must be checked. Air leaking. 1. Loose screws in housing.2. Damaged O...

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence, accidents, repairs or alterations or lack of mainte-nance. This is Gri...