Graham Field LF1031FP - Manual

Page 2 - and; Lumex; are registered trademarks of GF Health Products, Inc.; CONTENTS

1031FP-INS-LAB-RevA11 2 GF Health Products, Inc. is not responsible for typographical errors. Packaging, warranties, products and specifications are subject to change without notice. Graham-Field and Lumex are registered trademarks of GF Health Products, Inc. CONTENTS 1 INTRODUCTION ...................

Page 3 - INTRODUCTION; could result in death or serious personal injur y.

1031FP-INS-LAB-RevA11 3 1 INTRODUCTION Congratulations on your purchase of a Lumex patient lift. The following pages will provide you with important safety and operating instructions on the use of patient lifts, slings, and accessories, as well as maintenance and warranty information. Read this manu...

Page 4 - SAFETY PRECAUTIONS; CARE AND MAINTENANCE; WARNINGS

1031FP-INS-LAB-RevA11 4 2 SAFETY PRECAUTIONS IMPORTANT: Before using patient lift, please read and adhere to the following safety precautions and warnings. Failure to do so could result in serious personal injury or damage to your patient lift.Always consult your healthcare professional to determine...

Page 6 - FEATURES

1031FP-INS-LAB-RevA11 6 3 FEATURES push handle 6-point spreader bar (suspension) hydraulic pump pump knob (pump locking and unlocking) adjustment handle (boom height adjustment) mast boom (height-adjustable) locking casters foot pedal (base width adjustment) base (width-adjustable) swivel casters LF...

Page 7 - HANDLING PROCEDURES; SHIPPING AND TRANSPORTATION INSTRUCTIONS; Unpacking; rier or your authorized Lumex Dealer.; Inspection

1031FP-INS-LAB-RevA11 7 4 HANDLING PROCEDURES SHIPPING AND TRANSPORTATION INSTRUCTIONS If the patient lift is to be reshipped by common carrier, it should be packed in the same carton in which it was received. Unpacking 1. Check for any obvious damage to the carton or its contents. If damage is evid...

Page 8 - ASSEMBLY INSTRUCTIONS; COMPONENTS; Item

1031FP-INS-LAB-RevA11 8 5 ASSEMBLY INSTRUCTIONS Components are shown in illustration below and called out in list below illustration. COMPONENTS Components: LF1031FP Hydraulic Patient Lift with Foot Pedal 9 2 4 10 3 1 7 658 Item Qty Description 1 1 Mast/Boom/Pump assembly 2 1 Base 3 2 L-insert 4 2 P...

Page 9 - ASSEMBLY

1031FP-INS-LAB-RevA11 9 ASSEMBLY 1. Remove the locking pin from the mast sleeve located on the rear of the base. 2. Install the L-inserts in the base. 3. With the boom pointed in the same direction as the base legs, insert the mast into the sleeve. 4. Insert the locking pin through the holes of the ...

Page 11 - OPERATING INSTRUCTIONS; LIFTING THE PATIENT; WARNING: Use only Lumex slings with Lumex patient lifts.; Lifting the patient from a bed; must be locked in the maximum open position.; Lowering the patient onto a bed

1031FP-INS-LAB-RevA11 11 6 OPERATING INSTRUCTIONS LIFTING THE PATIENT WARNING: Do not attempt to transfer a patient without prior approval of the patient’s healthcare professional and without having read the instructions and practiced using the patient lift. WARNING: Use special care for those patie...

Page 12 - Lifting the patient from the floor; feet on the base, straddling the column for extra stability.; Lowering the patient to the floor; Reverse the above procedures to lower.; transferring a patient to and from a wheelchair.; Then cross the loops, one through the other.

1031FP-INS-LAB-RevA11 12 Lifting the patient from the floor 1. Position the patient lift behind the patient, placing a pillow over the base to protect and sup- port the patient’s head and neck. Place the patient's head carefully on the pillow. The patient lift should be positioned with the spreader ...

Page 13 - Removing the sling; locks in locked position.

1031FP-INS-LAB-RevA11 13 ping forward. Removing the sling Gently pull the leg sections to the side, out from under the patient’s thighs. Standing by the pa-tient’s side, lean the patient forward while supporting the patient with one hand. Pull the sling up from behind the patient’s back and position...

Page 14 - CARE AND MAINTENANCE; BEFORE EACH USE

1031FP-INS-LAB-RevA11 14 7 CARE AND MAINTENANCE Proper care and maintenance are essential to keeping your Lumex patient lift in a safe operating condition. In addition to inspecting the unit before each use, periodic maintenance checks should be done. We further recommend that this unit be serviced ...

Page 16 - Removal of Existing Pump; Follow the instructions in this; INSTALLATION OF; wrenches to remove

1031FP-INS-LAB-RevA11 16 INSTALLATION OF 1010S005 HYDRAULIC PUMP Removal of Existing Pump 1. Follow the instructions in this section to remove the existing pump, shown at near right. If installing pump for the first time, proceed to INSTALLATION OF NEW PUMP . 2. Remove the top of the exist- ing pump...

Page 17 - Installation of New Pump; Attach the bottom of the new hydraulic pump; FRONT; ” label toward you, as shown at far; WARNING: Ensure that the Hydraulic Pump

1031FP-INS-LAB-RevA11 17 Installation of New Pump Info: The hardware for attaching the Hydrau-lic Pump (GF #1010S005) to the mast and boom comes with the lift frame. 1. Attach the bottom of the new hydraulic pump to the lower mast bracket with the pressure knob and pump lever toward the bottom of th...

Page 18 - MAINTENANCE SCHEDULE

1031FP-INS-LAB-RevA11 18 MAINTENANCE SCHEDULE Info: Only qualified persons should service and repair your Lumex patient lift. Regular maintenance of your patient lift is necessar y to ensure continuing proper and safe opera-tion. Read and observe the following recommended maintenance schedule: Item ...

Page 19 - TROUBLESHOOTING

1031FP-INS-LAB-RevA11 19 8 TROUBLESHOOTING WARNING: If you experience a problem with your lift and are unable to ser vice it your- self, contact your Lumex dealer. SYMPTOM POSSIBLE CAUSE ACTION Patient lift does not go up or down Air in the cylinder Bleed the cylinder by turning the release knob and...

Page 20 - * Specifications are subject to change without notice.

1031FP-INS-LAB-RevA11 20 9 SPECIFICATIONS * Info: All dimensions are given in inches unless otherwise specified. Base width Open: 39.7"Closed: 25.4" Base height Clearance 4.5" Base length 51" Lifting height rangeInfo: As measured from point where sling attaches to spreader bar. Minim...

Page 21 - 0 LIMITED WARRANTY; GF Health Products Inc.

1031FP-INS-LAB-RevA11 21 10 LIMITED WARRANTY GF Health Products Inc. warrants this product to be free from manufacturing defects in material and workmanship for its period of warranty that is in accordance with industry standards. This warranty is extended only to the original purchaser/consumer or ...

Graham Field LF1031FP - Manual

Table of Contents:

Summary

Other Graham Field Models