Graco 3A1333A- User Manual
Graco 3A1333A– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 3 – Install the USB Module
- Page 4 – Install the Power CAN Cable
- Page 6 – Graco Standard Warranty
Instructions/Parts
24H253 USB
Module Kit
3A1333A
ENG
To add a USB Module to a ProMix
®
2KE Electronic Proportioner. For professional use only.
Kit Parts
▲
Replacement Danger and Warning labels, tags, and
cards are available at no cost.
NOTE: You must order a CAN cable separately to com-
plete the installation:
•
For systems approved for Hazardous locations (IS,
alternator powered), order Part No. 15V782 Cable.
•
For systems approved for non-Hazardous locations,
(non-IS) order Part No. 15V778 Cable.
Important Safety Instructions
Read all warnings and instructions in this
manual and in your separate ProMix 2KE
manuals. Save these instructions.
Ref.
Part
Description
Qty.
340
16F358 USB MODULE with TOKEN (T);
see manual 3A1244 for token
instructions
1
341
121417 SCREW
4
342
102063 WASHER
1
343
195875 SCREW
1
345
24H084 USB HARNESS
1
346
15R325 COVER, bulkhead
1
347
▲
15X214 LABEL, warning
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 3A1333A Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Warnings 3A1333A 3 Install the USB Module 1. Disconnect main power. Open the control box. 2. Remove the five knockouts (K) on the top of the con-trol box. See F IG . 1. 3. Install the USB module using four screws (341). The fifth screw (343) and star washer (342) must be installed in the center knoc...
Warnings 4 3A1333A Install the Power CAN Cable Non-IS Systems 1. Remove the user interface cable from J8 of the fluid control module and plug it into connector P3 of the USB module. See F IG . 2. 2. Connect Part No. 15V778 Cable (order separately) to J8 of the fluid control module and to connector P...
