Graco 3A1215C- User Manual

Operation 3A1215C 5 Menus Information Readout (Startup/Main Menu) Measuring Counter: Resets every time HOLD/RESET is activated. The First Menu is used to set the paint length of a skip line and the frequency of that length. 1. Set paint length with adjacent arrows.2. Set cycle length with adjacent a...

Operation 6 3A1215C Distance Calibration The Distance Calibration Menu is used to calibrate the system against a measured distance (see Distance Calibration Procedure , page 9). 1. Use adjacent arrows to enter the length of the mea- sured course. 2. Press at the beginning of the measured course. 3. ...

Operation 3A1215C 7 Setup Distance Units A Distance Units Bead Gun Enable/Disable Adjust Display Contrast Display SPACE or CYCLE GALLONS or LITERS B C D E System Type F A B A English ft/in/mphMetric m/cm/kph C Exit Changing units will reset to factory settings Bead Gun Solenoids B A Solenoid 2 ENABL...

Operation 8 3A1215C Marker Layout Mode Change Value Set space sizes up to 8 consecutive measurements. By leav-ing zeros in any space, Marker Layout Mode will skip to the next measurement in a continuous loop. DOT Size (sec) The amount of time the gun will be activated. NOTE: Lowering system pressure...

Operation 3A1215C 9 Distance Calibration Procedure NOTE: Although the RoadLazer is calibrated prior to shipping, the sensor will need to be recalibrated periodi-cally due to wheel wear, and also whenever the gun-arm wheel is replaced. NOTE: Before recalibrating, ensure that the gun-arm wheel is infl...

Operation 10 3A1215C Example: Painting Two Solid Lines with the One-Operator System Delay ™ On 1. Turn on System Delay. 2. Set guns 1 and 2 in the solid position and the RESET/HOLD switch in the hold position. 3. Align the mechanical reference point with the begin- ning of the area to be painted (A)...

Troubleshooting 12 3A1215C Troubleshooting Problem Cause Solution Control will not turn on. 12 VDC power supply low, or discon-nected. Connect the I/O cable. Charge the RoadLazer battery. Check the battery connections. Guns will not spray. Various causes. Toggle RESET on the controller. Check the pa...

Parts 14 3A1215C Parts Technical Data PO W ER ON OFF RE SE T HOLD BE ADS O N BEA D TES T A B C D E F SY ST EM DE LA Y ST AR T SK IP SP AC E ME NU ME NU PR OG RAM MA BLE SKIPLINE CO NT RO L PO W ER ON OF F RE SET HO LD BEAD S ON BE AD TE ST A B C D E F SY ST EM DE LA Y ST AR T SK IP SP AC E ME NU ME ...

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. For patent information, see www.graco.com/patents Original instructions. This manual contains Engl...