Graco 3A0860F- User Manual
Graco 3A0860F– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warnings; WARNING
- Page 3 – Installation; Outlet Adapters; USP Divider Port Combination; Pressure Relief Procedure
- Page 4 – Purging Air from Pump to USP Valve Lines; Purging Air After Adding or Replacing a USP Valve Module
- Page 5 – Blockages; Cleaning Valves
- Page 6 – Parts
- Page 7 – Technical Data; Dimensions; Mounting Pattern
- Page 8 – Outlet Pattern Numbering
- Page 9 – Notes
- Page 10 – Graco Standard Warranty; Graco Information
Instructions
USP Valve
3A0860F
Uniblock Series Progressive Valve for oil and grease lubrication.
5076 psi (35 MPa, 350 bar) Maximum Working Pressure
Models
For all models:
•
Discharge per outlet = 0.012 in
3
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Model No.
No. of
Outlets
Inlet Thread
24E406
6
1/8 NPT
24E407
8
1/8 NPT
24E408
10
1/8 NPT
24E409
12
1/8 NPT
24E410
14
1/8 NPT
24E411
16
1/8 NPT
ti13743
EN
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 3A0860F Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...
Installation 3A0860F 3 Installation The USP Valve should be ready to install in your sys-tem. It has been factory-tested and should not require any additional modification. As long as lubricant is supplied under pressure, the valve will continue to operate . Whenever lubricant flow ceases, the valve...
Installation 4 3A0860F Purging Air from Pump to USP Valve Lines Steps 1- 3, refer to F IG . 3. 1. Install the line from the system pump to the USP valve. Do not completely tighten the connection at the valve’s lube inlet. 2. Cycle the system pump until air-free lubricant is observed flowing from the...
