Graco 3A0860F- Manuals

Page 2 - Warnings; WARNING

Warnings 2 3A0860F Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...

Page 3 - Installation; Outlet Adapters; USP Divider Port Combination; Pressure Relief Procedure

Installation 3A0860F 3 Installation The USP Valve should be ready to install in your sys-tem. It has been factory-tested and should not require any additional modification. As long as lubricant is supplied under pressure, the valve will continue to operate . Whenever lubricant flow ceases, the valve...

Page 4 - Purging Air from Pump to USP Valve Lines; Purging Air After Adding or Replacing a USP Valve Module

Installation 4 3A0860F Purging Air from Pump to USP Valve Lines Steps 1- 3, refer to F IG . 3. 1. Install the line from the system pump to the USP valve. Do not completely tighten the connection at the valve’s lube inlet. 2. Cycle the system pump until air-free lubricant is observed flowing from the...

Page 5 - Blockages; Cleaning Valves

Installation 3A0860F 5 Blockages Blocks require a higher than normal pumping pressure. Depending on the application or system design, this blockage will usually result in a complete loss of lubri-cant flow into the total system and no bearing will be receiving lubrication. The loss of flow due to a ...

Page 6 - Parts

Parts 6 3A0860F Parts * 2 3 1 Torque to 15 - 18 ft.-lbs (20.3 - 24.4 N.m) 1 1 Torque to 8 - 10 ft.-lbs (10.8 - 13.5 N.m) 2 2 ti14066 5 4 FN Part No. Description Qty 1 VALVE, 4 piston honed, models 24E406, 24E407 1 VALVE, 6 piston honed, models 24E408, 24E409 1 VALVE, 8 piston honed, models 24E410, 2...

Page 7 - Technical Data; Dimensions; Mounting Pattern

Technical Data 3A0860F 7 Technical Data Dimensions Wetted Parts Steel, Fluorocarbon Maximum Pressure 5076 psi (35 MPa, 350 bar) Maximum Operating Temperature Fluorocarbon seals 350°F (177°C) Lubricant Oil or grease up to NLGI #2 Output Volume 0.012 in 3 Inlet Threads 1/8 - 27 NPT Outlet Adapter Thre...

Page 8 - Outlet Pattern Numbering

Technical Data 8 3A0860F Outlet Pattern Numbering NOTE: • Port combinations do not continue across factory plugged outlets. Factory plugged ports are included on 6, 10 and 14 outlet USP Valve models. On the following diagrams the factory plugged outlets are represented as blacked por ts. • Do not re...

Page 9 - Notes

Page 10 - Graco Standard Warranty; Graco Information

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 3A0860 Graco Headquarters: Minneapolis Int...