Graco 310696F- User Manual
Graco 310696F– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Contents; WARNING
- Page 4 – Installation; Overview; Installation Requirements; Fluid Supply; Mounting
- Page 5 – Vertical Mounting; Horizontal Mounting; Fluid Line Connection
- Page 6 – Power Supply Installation; Cable Connections; Power Harnesses and Cables; Meter Signal Cable
- Page 8 – Grounding; Flow Meter Sensor; Meter Fluid Manifold
- Page 9 – Operation; Start Up; Basic Installation Settings
- Page 10 – Measuring values; Function Matrix
- Page 12 – Parts
- Page 13 – Dimensions
- Page 14 – Graco Standard Warranty
Instructions
Coriolis Meter Kit
310696F
EN
For use with ProMix™
II
, ProMix
™
Auto, and ProControl proportioners in a non-hazardous
environment only. If a Coriolis meter is installed on one of these three proportioners, the
entire system is no longer approved for a hazardous environment.
Not approved for use in explosive atmospheres or hazardous locations. For professional
use only.
Part No. 234563
2300 psi (16 MPa, 160 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this manual
and in your proportioner manual. Save these
instructions.
TI4930A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Warnings 2 310696F Contents Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation Requirements . . . . . . . . ....
Installation 4 310696F Installation Overview The Endress+Hauser Promass ® 80A flow meter pro- vides a configurable and highly accurate means of mea-suring fluid flow. It uses the Coriolis principle to measure mass flow and fluid density and also measures fluid temperature, using an integrated temper...
Installation 310696F 5 Vertical Mounting Fluid Flow Upward - preferred method Mounting so fluid flow is upward through the meter is preferred as this allows solids to settle out and air to rise away from metering tube. F IG . 1. Install the check valve provided at the meter inlet to min-imize pulsat...
