Graco 309273 - Manual
Graco 309273 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PRESSURE RELIEF; – Do this when cleaning, repairing or shuting down sprayer; Turn power; OFF; Put drain tube in pail; WARNING
- Page 3 – Component Identification; Paint position
- Page 4 – Connect Graco airless hose to sprayer.; Setup
- Page 6 – Plug power supply cord into a properly grounded; Startup; to flush out storage oil shipped in
- Page 7 – Do not stop leaks with your hand or a rag!; ON
- Page 8 – General Surfaces Tip Recommendations Chart; Trigger gun again into flushing fluid pail until
- Page 10 – Put trigger safety ON, return SwitchTip
- Page 11 – Cleanup; PAINT
- Page 12 – Remove siphon tube set from paint and place
- Page 13 – Take trigger safety; Turn prime valve down and allow
- Page 15 – Trouble Shooting
- Page 16 – Wrap power cord and; Graco Phone Number
Ultra Max
t
Electric Airless Sprayers
Operating Instructions
The intent of these instructions is to provide the new painter with a quick and easy reference to
become familiar with airless sprayers. This does not replace the Instruction Manual supplied
with this sprayer. Read and understand the instructions and warnings in that manual.
Important Note:
The Graco Standard product line has a wide range of sprayer units that vary
slightly. The basic operations procedures are the same for all sprayers. Some illustrations may
not be applicable to the particular sprayer purchased.
Tools Required:
D
Two adjustable wrenches
D
Two 5 gallon metal pails
D
Grounding wires and clamps for pails
D
Pencil
Suggested proper clothing:
D
Respirator
D
Safety glasses
309273
Rev. D
How To Perform:
S
Component Identification
3
. . . . . . .
S
Setup
4
. . . . . . . . . . . . . . . . . . . . . . . . . . .
S
Startup
7
. . . . . . . . . . . . . . . . . . . . . . . . . .
S
SMARTCONTROL
t
9
. . . . . . . . . . .
S
Cleanup
11
. . . . . . . . . . . . . . . . . . . . . . . .
S
Trouble Shooting
15
. . . . . . . . . . . . . .
S
Maintenance
16
. . . . . . . . . . . . . . . . . . .
S
Storage
16
. . . . . . . . . . . . . . . . . . . . . . . .
S
Tip Wear
16
. . . . . . . . . . . . . . . . . . . . . . .
3300 psi (227 bar 22.7 MPa) Maximum Working Pressure
GRACO INC.
P.O. BOX 1441 MINNEAPOLIS, MN
55440–1441
E
COPYRIGHT 2000, GRACO INC.
Graco Inc. is registered to I.S. EN ISO 9001
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 309273 PRESSURE RELIEF – Do this when cleaning, repairing or shuting down sprayer WASTE RESÍDUOS À JETER DESECHO 1. Turn pressure to lowest setting. Turn power OFF . Unplug sprayer. 2. Trigger gun to relieve pressure. 3. Put drain tube in pail . Turn prime valve down. WARNING Fire and explosion ha...
3 309273 Power Switch Pressure Control Component Identification Suction Tube Filter Prime Valve Prime/drain position Paint position Spray Gun Trigger Safety Put trigger safety ON when not spraying. Take trigger safety OFF before triggering gun. Digital Display (Not available on all models) 15/20A Sw...
4 309273 1. Connect Graco airless hose to sprayer. Tighten securely. 2. Connect other end of hose to gun. Setup 3. Tighten securely. 4. Remove tip guard.
